D-Link GO-SW-24G User Manual

Page of 27
 
Rresilient Llink – A pair of ports that can be configured so that one will take over data 
transmission should the other fail. See also main port and standby port
RJ-45 – Standard 8-wire connectors for IEEE 802.3 10BASE-T networks. 
RMON  –  Remote Monitoring. Subset of SNMP MIB II, which allows monitoring and 
management capabilities by addressing up to ten different groups of information. 
RPS    Redundant Power System. A device that provides a backup source of power 
when connected to the Switch. 
Server  Farm  –  A cluster of servers in a centralized location serving a large user 
population. 
SLIP  – Serial Line Internet Protocol. A protocol that allows IP to run over a serial line 
connection. 
SNMP  –  Simple Network Management Protocol. A protocol originally designed to be 
used in managing TCP/IP internets. SNMP is presently implemented on a wide range of 
computers and networking equipment and may be used to manage many aspects of 
network and end station operation. 
Spanning Tree Protocol – (STP)  A bridge-based system for providing fault tolerance 
on networks. STP works by allowing you to implement parallel paths for network traffic, 
and to ensure that redundant paths are disabled when the main paths are operational 
and enabled if the main paths fail. 
Stack – A group of network devices that are integrated to form a single logical device. 
Standby port –  The port in a resilient link that will take over data transmission if the 
main port in the link fails. 
Switch  –  A device that filters, forwards, and floods packets based on the packet’s 
destination address. The Switch learns the addresses associated with each switch port 
and builds tables based on this information to be used for the switching decision. 
TCP/IP  –  A layered set of communications protocols providing Telnet terminal 
emulation, FTP file transfer, and other services for communication among a wide range 
of computer equipment. 
Telnet  –  A TCP/IP application protocol that provides virtual terminal service, letting a 
user log in to another computer system and access a host as if the user were 
connected directly to the host. 
TFTP  –  Trivial File Transfer Protocol. Allows you to transfer files (such as software 
upgrades) from a remote device using your switch’s local management capabilities. 
UDP  –  User Datagram Protocol. An Internet standard protocol that allows an 
application program on one device to send a datagram to an application program on 
another device. 
VLAN    Virtual LAN. A group of location-  and topology-independent devices that 
communicate as if they are on a common physical LAN. 
VLT  Virtual LAN Trunk. A Switch-to-Switch link which carries traffic for all the VLANs 
on each Switch. 
VT100    A type of terminal that  uses ASCII characters. VT100 screens have a text-
based appearance. 
27