Tripp Lite SmartPro 100/110/120V 1.05kVA 650W Line-Interactive Sine Wave UPS, SNMP, Webcard, Tower, USB, DB9 Serial SMART1050SLT User Manual

This manual contains instructions and warnings that should be followed during the
installation, operation and storage of all Tripp Lite UPS Systems. Failure to heed these
warnings will void your warranty.

• Install your UPS indoors, away from excess moisture or heat, conductive contaminants,

dust or direct sunlight.

• For best performance, keep the indoor temperature between between 32º F and 104º F (0º C

and 40º C).

• Leave adequate space around all sides of the UPS for proper ventilation. 

• Connect your UPS directly to a properly grounded AC power outlet. Do not plug the UPS

into itself; this will damage the UPS.

• Do not modify the UPS's plug, and do not use an adapter that would eliminate the UPS’s

ground connection.

• Do not use extension cords to connect the UPS to an AC outlet.

• If the UPS receives power from a motor-powered AC generator, the generator must provide

clean, filtered, computer-grade output.

• Do not use Tripp Lite UPS Systems for life-support applications in which a malfunction or

failure of an Tripp Lite UPS System could cause failure or significantly alter the
performance of a life-support device.

• Do not connect surge suppressors or extension cords to the output of your UPS. This might

damage the UPS and will void the surge suppressor and UPS warranties.

• Batteries can present a risk of electrical shock and burn from high short-circuit current.

Observe proper precautions. There are no user-serviceable parts inside the UPS. Do not
open the UPS except to perform battery replacement. Do not open batteries. Do not short or
bridge the battery terminals with any object. Unplug and turn off the UPS before
performing battery replacement. Use tools with insulated handles. Battery replacement
should be performed only by authorized service personnel using the same number and type
of batteries (Sealed Lead-Acid). Do not dispose of the batteries in a fire. The batteries are
recyclable. Refer to your local codes for disposal requirements or in the USA only call 
1-800-SAV-LEAD or 1-800-8-BATTERY (1-800-822-8837) or visit www.rbrc.com for
recycling information. Tripp Lite offers a complete line of UPS System Replacement
Battery Cartridges (R.B.C.).Visit Tripp Lite on the Web at www.tripplite.com/support/
battery/index.cfm to locate the specific replacement battery for your UPS.

NOTE! after you plug the UPS into a live AC
outlet, the UPS will automatically charge its
batteries,* but will not supply power to its outlets
until it is turned ON.

* The BATTERY CHARGE LED will be the only LED illuminated

Models SMART1500SLT & SMART1050SLT:
All outlets provide battery backup and surge
protection for computers, monitors and other
critical devices. Model SMART750SLT: Select
outlets provide battery backup and surge
protection for computers, monitors and other
critical devices; select outlets provide surge
protection only for printers and other nonessential
devices.

Do not plug high-draw equipment such as laser

printers into the battery backup/surge

protection outlets.

Note: Your UPS is designed to support electronic equipment only.
You will overload the UPS if the total VA rating for all equipment
connected through the battery backup/surge protection outlets
exceeds the UPS's Output Capacity. To find your equipment's VA
ratings, look on their nameplates. If the equipment is listed in
amps, multiply the number of amps by 120 to determine VA.
(Example: 1 amp × 120 = 120 VA). If you are unsure if you have
overloaded the UPS's outlets, see “OUTPUT LOAD LEVEL”
LED description.

Press and hold the “STANDBY” button for one
second. The alarm will beep once briefly after one
second has passed. Release the button.