Epson 355 C11CC86409 Data Sheet
Product codes
C11CC86409
Windows
Mac
Windows
Mac
A
B
B
B
Windows
Mac
A
EN
Start Here
© 2013 Seiko Epson Corporation. All rights reserved.
1
Unpacking
2
Filling Ink
Install the ink bottle cap
tightly
;
otherwise ink may leak.
3
Connecting to the Computer
Do not connect the USB cable until you are instructed to do so.
If the Firewall alert appears, allow access for Epson applications.
Do not load paper above mark inside the edge guide.
Load paper with its printable side face up.
Load paper with its printable side face up.
Loading Paper and Copying
Loading Capacity (sheets) for copying
Important; must be observed to avoid damage to your equipment.
Plain Paper
11 mm
A4
Bright White Ink Jet Paper
80
Read This First
This product requires careful handling of ink. Ink may splatter when the ink tanks are filled or refilled with ink. If ink gets on your clothes or belongings, it may not
This product requires careful handling of ink. Ink may splatter when the ink tanks are filled or refilled with ink. If ink gets on your clothes or belongings, it may not
come off.
Remove all protective materials.
For initial setup
Do not open the initial setup ink bottle package or the refill ink bottle package until you are ready to fill the
ink tank. The ink bottle is vacuum packed to maintain its reliability.
Unhook.
Open and remove.
.
Do not pull the tubes.
Check position.
Snap off, remove, and then install.
Match the ink color with the tank, and
then fill with
all of the ink
.
Install.
Repeat steps to for each ink bottle.
Install securely.
Close.
Before printing, be sure to hook the ink tank unit onto the product. Do not lay
the ink tank unit down, or position the unit higher or lower than the product.
Use the ink bottles that came with your product.
Even if some ink bottles are dented, the quality and quantity of ink are guaranteed, and they can be used safely.
Epson cannot guarantee the quality or reliability of non-genuine ink. The use of non-genuine ink may cause damage that is not covered by Epson’s
Even if some ink bottles are dented, the quality and quantity of ink are guaranteed, and they can be used safely.
Epson cannot guarantee the quality or reliability of non-genuine ink. The use of non-genuine ink may cause damage that is not covered by Epson’s
warranties.
Transporting
Secure print head.
Set transportation lock.
Install securely.
Make sure to hook on.
Without ink bottles, set in
original or similar box.
Keep the product level as you transport it. Otherwise, ink
may leak.
Be sure to keep the ink bottle upright when tightening
the cap, and take measures to prevent ink from leaking
as you transport it.
Connect and plug in.
Press for 3 seconds until starts
flashing. Charging ink is started.
Charging ink takes about 20 minutes.
Wait until the light turns on.
Insert.
Check and proceed.
Select and follow the instructions.
Select and follow the instructions.
Windows 7/Vista: AutoPlay
window.
Only the software with a selected check box is installed. Epson Online Guides
contain important information such as troubleshooting. Install them if necessary.
After you move it, remove the tape securing the
print head and the covers of ink tanks, then set the
transportation lock to the unlocked position. If you
notice a decline in print quality, run a cleaning cycle or
align the print head.
Store the covers at the side of the
product.
Turn on.
Hook onto.
The illustrations in this guide may
differ from your actual product.