Funai WD6D-M100 WD6DM100 Data Sheet

12

EN

Install 2 R6 (1.5 V) batteries (supplied) into the remote 
control, carefully match with the polarity indicated inside the 
battery compartment.

• Incorrect use of batteries can result in hazards such as 

leakage and bursting. 

• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (–) ends of each 

battery match the indications inside the battery 
compartment.

• Remove batteries if the equipment will not be used for a 

month or more.

• When disposing used batteries, please comply with 

governmental regulations or the public instructions for 
environmental protection that apply in your country or area.

• Do not recharge, short-circuit, heat, burn or disassemble 

batteries.

• Make sure there is no obstacle between the remote control 

and the remote control sensor on the unit.

• Use within the operating range and angle as shown.

• The maximum operable range as follows:

• Remote control operation may become unreliable if the 

remote control sensor of the unit is being exposed by the 
strong sunlight or fluorescent light.

• Remote controls for different devices can interfere with each 

other. Be careful when using remote controls for other 
equipment located close to the unit.

• Replace the batteries when the operating range of the 

remote control reduces.

You must select which component you want to operate first. 
Press [DVD] or [VCR] on the remote control or [SELECT] on 
the front panel.

Press [DVD] on the remote control or [SELECT] on the front 
panel.
(Verify that the DVD indicator is lit in green.)

Press [VCR] on the remote control or [SELECT] on the front 
panel.
(Verify that the VCR indicator is lit in orange.)

approximately 7 m

Either side of centre: approximately 5 m within 30 degrees

2

1

3

Within 
about 5 m

5 m (30°)

7 m

5 m (30°)

DVD button

VCR button

button

indicators

E9TF0ED_EN.book  Page 12  Wednesday, March 17, 2010  1:32 PM