Funai WD6D-M100 WD6DM100 Data Sheet

23

EN

Select “Auto Tuning” using [K

\ L], then press 

\OK].

The unit will start storing channels available in your area.

The tuner scans and memorises all the active DVB 
channels (TV / Radio) in your area. 

\OK] to exit.

• After auto tuning is completed, the lowest memorised 

DVB channels appears on the screen.

• You can use [PROG.

G \ H] to change the DVB 

channels.

• If you press [RETURN

\BACK] or [SETUP] during the 

scanning, auto tuning will be cancelled. 

You can preset a DVB channel manually and individually.

Select “Manual Tuning” using [K

\ L], then 

\OK].

Select your desired position number using 
[K

\ L], then press [ENTER\OK].

• The tuner will begin to search up or down automatically. 

When a DVB channel is found, the unit will stop 
searching.

• When “Auto” is selected, the unit will search for the 

channels which have not been stored in channels 
memory. 

This unit has “Service Update” function which searches and 
stores newly available digital channels automatically at 8:00. If 
a new channel is found, a message will appear on the screen 
when you turn on the DVB channel at first time after storing a 
new channel. Press any button to clear the message.

You can set the country for receiving your local channels 
properly. This setting is mainly for digital channels.

In stop mode, press [SETUP]. Select “General 
Setting” using [K

\ L], then press [ENTER\OK].

Select “Channel” using [K

\ L], then press 

\OK].

Select “Country” using [K

\ L], then press 

\OK].

Select your desired country using [K

\ L], then 

\OK].

Digital channels cannot be received properly for the 
countries not listed above.
In such case, select “Other”.

The following operations are available while viewing TV 
channels through this unit’s tuner.

To switch DVB, analogue and external input (AV1/AV2/
DV(AV3)) mode.
Press [INPUT SELECT] repeatedly to select DVB, analogue 
or external input mode.
The mode changes as follows:

You can select external input mode (AV1/AV2/DV(AV3)) by 
pressing [PROG.

G \ H] repeatedly. 

The mode changes as follows:

You can select a channel using [PROG.

G \ H] or directly 

enter the channel using [the Number buttons].

Notes on using [the Number buttons]:
• For one or two-digit number channels, the channels will be 

identified for 2 seconds after you press the channel number. 
You can only select channels 1~899 (Digital) or 
1~99 (Analogue).
If you cannot get a “Station Name” of Analogue channel, it is 
not indicated with a channel number.

DVB mode

Analogue mode

External input mode

AV1

AV2

DV(AV3)

External input mode (with [PROG.

G \ H] buttons)

E9TF0ED_EN.book  Page 23  Wednesday, March 17, 2010  1:32 PM