Funai WD6D-M100 WD6DM100 Data Sheet

73

EN

Before requesting service for this unit, check the table below for a possible cause of the problem you are experiencing. Some 
simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation.

Others

The power does not turn on.

• Check that the AC power cord is connected securely.
• Batteries of the remote control are weak.
• Press [TIMER SET] to cancel the timer-standby mode. (When both DVD and 

VCR is in timer-standby mode, you cannot operate the unit.)

The unit turns on automatically without 
any operation.

• The unit turns on automatically 2 seconds before the timer recording.

The unit does not function.

• “

” or error message appears if the operation is prohibited.

• Batteries of the remote control are weak or exhausted.

No picture, sound or menu appears on 
the screen.

• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Check if a correct external input channel is selected on your TV. (See page 23.)
• Check if you have completed “Channel” setting. (See pages 21-23.)

“Clock” setting and “Channel” setting 
cannot be performed.

• If a recording is in progress, these operations cannot be performed.

The unit does not operate properly.

• Moisture has condensed inside the unit. Remove the disc and leave the unit 

turned on for about 2 hours until the moisture evaporates. (See page 3.)

The clock display does not appear on 
the front panel display.

• Check that the AC power cord is connected securely.
• (In case of power failure) Check the breaker and “Clock” setting.
• When the unit is in standby mode, front panel display is off because Power 

Saving mode is applied to this product.

When you forget the password for 
parental lock.

• Please cancel the password and the set level. (See page 64.)

DV signal cannot be input.

• Before connection, turn on the power supplies for both this unit and the DVC, 

and make sure that these units have stopped.

• Only a “DVC-SD” signal can be input from the DVC to this unit. Other types of 

signals are not supported.

• Do not connect any device other than the DVC. Even if a recorder or PC with 

another DV terminal is connected, the DV function will not operate.

• If the DVC is not recognised after connection, turn off the power supply for the 

unit and re-connect the DVC.

The DVC cannot be operated with this 
unit.

• Signal input or DVC operation from this unit may be disabled depending on the 

type of DVC.

• If a DVC signal cannot be input, use an external input (AV2) for analogue 

connection via audio/video cables. Use Scart adaptor for connecting to AV2.

• DVC control may be disabled depending on the type of DVC, even in a mode 

other than camera mode. In this case, switch to DVD control and execute the 
normal recording procedure while operating the DVC.

Certain functions of the DVC cannot 
operate.

• Some functions may not operate depending on the type of DVC. For example, if 

the DVC does not support slow playback mode, the slow playback function is 
disabled.

• With DV (AV3), the disc display menu does not appear unless disc playback is 

executed.

DV audio signal cannot be switched.

• For recording with the DVC, the recording audio signal can be set to 12 bits or 

16 bits. However, when 16-bit recording mode is selected, audio signal cannot 
be switched. To record an audio signal, set it to 12 bits.

E9TF0ED_EN.book  Page 73  Wednesday, March 17, 2010  1:32 PM