Panasonic Limit switch 115 Vdc, 250 Vac 10 A Spring-loaded rod momentary AZ7166CEJ IP64 1 pc(s) AZ7166CEJ Data Sheet

33

1. When the switch is to be used in
places where oil or is abundant, bore a
drain hole in the bottom of the terminal
cover.
2. Avoid places where highly acid or
alkaline fluids are used or high tempera-
tures prevail.
3.Wiring
(1) Remove the terminal cover with a v
driver.

(2) Insert the lead wire through the
knock-out of the terminal cover.
(3) Connect the lead wire to the terminal.
When connecting the terminals with the
fasten lug, those with the insulation
sleeve are recommended.
(4) The terminal cover can be mounted
in both directions.
In this case, fasten the terminal cover in
the opposite direction.

• For epoxy-sealed terminal types, there
are two types by the cord outlet direction;
N.C. side and COM side.
4. Flexible rod type
(1) Put the detective object to the tip of
plastic part.
(2) Avoid pushing the tip of actuating
spring in the direction of axis. In the
places of oil or water splashes and much
dust area, use the limit switch with keep-
ing the actuating spring in the vertical
direction.

Standard

N.C.

COM

ML (AZ7)

04/2005