Graupner Hendheld RC 2.4 GHz No. of channels: 5 33110 User Manual
Product codes
33110
91
Using the transmitter for the fi rst time
Click on “OK”, then switch the transmitter off and fi -
nally disconnect the PC or laptop.
nally disconnect the PC or laptop.
If the progress bar does not move forward, close the
program and repeat the update procedure, taking
note of any error messages which might appear.
program and repeat the update procedure, taking
note of any error messages which might appear.
4. Initialisation of the transmitter
After a successful update process you MUST - befo-
re re-use the transmitter - proceed an initialization for
safety reasons:
Press and hold to the BIND-Button on the transmitter
and turn it on. Now release the BIND-Button. Except
the binding information all other necessary pre-pro-
grammed settings in the transmitter are reset to fac-
tory settings and must be entered again if needed.
re re-use the transmitter - proceed an initialization for
safety reasons:
Press and hold to the BIND-Button on the transmitter
and turn it on. Now release the BIND-Button. Except
the binding information all other necessary pre-pro-
grammed settings in the transmitter are reset to fac-
tory settings and must be entered again if needed.
Attention: When initialisation in mode „normal“ is
complete, the transmitter will be in Fail-Safe setting
mode (page 111), if you do not want to program any-
thing here, turn off the transmitter now.
complete, the transmitter will be in Fail-Safe setting
mode (page 111), if you do not want to program any-
thing here, turn off the transmitter now.