Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Data Sheet

As with all radio frequency transmissions, the 

strongest area of signal transmission is from the 

sides of the transmitter's antenna. As such, the 

antenna should not be pointed directly at the model. 

If your flying style creates this situation, easily 

move the antenna to correct this situation.

Displays the "non-default condition" warning.

• Blinking
  Power  switch  is  turned  on  when  any 

condition  switch  is  activated  (in  the  ON 

state).

Displays the state of radio frequency 

transmission.

• Off
  Radio waves are in the OFF state.
• On
  Radio waves are being transmitted.
• Blinking
  Range check mode.

The status of the transmitter is displayed by LED 

at the bottom left and right sides of the "T14SG" 

logo.

•Rotating antenna
The antenna can be rotated 90 degrees and angled 

90 degrees.  Forcing the antenna further than this 

can damage it.  The antenna is not removable.

90°

90°

Doing so may degrade the quality of the RF 

transmission to the model

There is the danger that the antenna wire will break and 

operation will become impossible.

There is the danger that the antenna wire will break and 

operation will become impossible.

Low power

High power

High power

It is not good for there to 

be a model on flight in the 

direction tip of an antenna.

If you have a transmitter 

at an angle of a figure, an 

antenna will be good to use 

it, bending 90 degrees.