Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Data Sheet

Use the small plastic screw driver that was 

included with your receiver. 

The Link/Mode Switch is also used for the CH 

mode selection. 

Use this connector when using a voltage 

telemetry device to send the battery voltage (DC0 ~ 

70V) from the receiver to the transmitter. 

You will need to purchase the optional External 

Voltage input cable (CA-RVIN-700) FUTM5551.

You  can  then  make  a  cable  with  an  extra 

connector to the External voltage connector.

Before using the receiver, be sure to read the 

precautions listed in the following pages.
Receiver R7008SB

"1 through 6": outputs for the channels 1 through 6
"7/B": outputs of  7 channels and power. 
"8/SB": outputs of  8 channels or S.BUS port.
[S.BUS Servo  S.BUS Gyro ]
*When using 8/SB as S.BUS, you have to set 

CH MODE of the following page to mode B or 

mode D.

"S.BUS2": outputs of  S.BUS2 port.
 [S.BUS2 Servo  S.BUS2 Gyro Telemetry Sensor ]
*When using 9 or more channels, use an S.BUS 

function or use a second R7008SB and link both to 

your transmitter.

Firmly insert the connector in the direction 

shown in the figure. Insert the S.BUS2 by turning it 

90 degrees.

＋

−

Do not connect either a switch 

or battery in this manner.

Receiver

*It will short-circuit, if it connected in this way. A short 

circuit across the battery terminals may cause abnormal 

heating, fire and burns.

This monitor is used to check the CH mode of 

the receiver.