Olight SR95 Data Sheet

Page of 1
Operator
's Manual
 LED Flashlight
TM
Olight Technology Co., Limited
www.olightworld.com 
Tel: +86-755-3351 8606
Fax: +86-755-3380 0207
Email: service@olightworld.com
TM
WE MAKE A DIFFERENCE
产品部件
随机配件
操作说明
Material
Aluminum body with anti-scratching type iii hard anodization
Dimension
325mm long, head diameter 90mm, body tube diameter 48.4 mm
Weight
1230. 5 g
Color
Black
LED
 Luminus SST-90 LED
Charger
 7800mAH 7.4v rechargeable lithium battery
Battery
 AC100~220V 50~60Hz   (input) 3A/8.4V
Reflector
Lens
Striking Bezel
Switch
O Ring
Tube Body Knurling
Output And Running Time
Special Mode
Beam IntensityIn Center
Maximum Throw
Waterproof
Impact Resistance
 Smooth reflector
 Tough ultra-clear tempering glass, with anti-reflective coating
Aluminum body with anti-scratching type iii hard anodization, 
Available to both head and tail part
 Side switch
 Two metal o rings with gold plating, which locate at the ends of the strap.
 Anti-slip human engineering knurling.
 Strobe 10 Hz
 129600 cd 
 720 m
 IPX6
 1.5 m
产品简介 
时隔两年,OLIGHT再次推出新一代的远射型强光手电王者SR90 Intimidator的兄弟产品SR95 
Intimidator
。 它使用LUMINUS 最新科技成果SST-90 LED作为发光源,有效提高亮度输出。同
时优化结构设计,增强产品散热性能,减轻产品重量,以及升级电锂包容量,改善按键手感,
提升产品整体性能和易用性。
Parts of the Flashlight
Included Items
SR95
 x 1
Manual (This manual)
Warranty Card 
 SR95 INTIMIDATOR
材质:书写纸
背带 x 1 
AC
充电器 x 1  
充电器电源线 x 1  
SR95
主机 x 1 
说明书(本说明书) 
保修卡
Strap x 1
AC Charger x 1
Power Cord 
for AC Charger x 1
size:130*90
Two years past, Olight now brought on another new generation of super bright SR95 Intimidator with 
long throw again. Compared with its brotherhood SR90, SR95 Intimidator takes SST-90 LED as its 
light source, which is the latest science and technology achievements of LUMINUS; SR95 has also 
optimized its structure design with more powerful heat dissipation, light weight, and upgraded lithium 
battery capacity to improve the integrate function and usability. 
 Product description
Battery Level
100%
1
2
3
4
5
6
7
8
9
10
11
12
Battery Level
100%
1
2
3
4
5
6
7
8
9
10
11
12
 Operation Instruction
Momentary lighting up
light up, but turn off when stop pressing.
Turn on/off:  power on or off when the switch button is pressed or released within 1 second, 
which will remember the last output brightness when you turn off.
Conversion between different modes:  Pressing and holding the power switch will change 
the output brightness among the three available outputs. Releasing the button will set the 
output.
Strobe:  a fast double click on the button will activate strobe. Under this mode, press the 
button and quickly release within 1 second to turn off the flashlight; keep pressing it more 
than 1 second to back into normal lighting mode; 
Lock-out function:  The flashlight can be locked out when power on, if you keep pressing 
the button for 3 circles of "Low-Middle-High" till turn off,. And then, the power switch will 
become temporarily invalid. 
Unlock the switch:  quickly triple click the button to unlock the switch. Or you can take off 
the battery, and reload after 30 seconds to unlock.   
Charging :  Open the rubber plug on the battery pack and connect the charger DC plugs to 
the battery pack.  The red indicator light shows that the battery pack is charging and the 
green light shows full. When the charger is not properly connected with battery pack, the 
indicator also show green colour.
Please pull out the DC plug and close the rubber plug to avoid damage, after charge 
finished; and make sure the charger is cutting-off as well.
Power Indication: Press the power indicator button at the tail, the green indicators will 
show the power status. Full 4 green indicators shows high power; the less green indicators 
on, the lower power it is; all the indicators off means power shortage (need to recharge 
immediately)
Note: Please disconnect the power after charge finished, and remember to take off the 
charger from the LED flashlight.
: keep pressing the button more than 1 second, the flashlight will 
特     征
材料
体    积
重    量
颜    色
反光杯
控制开关
透    镜
攻击头
发光二极管
电池
充电器
输出亮度 / 运行时间
特殊模式
中心光强度
最大射程
抗冲击
防    水
规     格
铝合金,表面三级硬质氧化
长325
毫米 头部直径
90
毫米 筒身直径
48.4
毫米
1230.5
克  
黑色
光面杯
头部轻触开关
钢化加硬玻璃,双面镀增透膜,单面防水膜
铝合金,表面三级硬质氧化, 头尾均具备
交流100~220V 50~60H
Z
输入,恒流恒压充电,3A/8.4V
Luminus SST-90 LED
7800mAh 7.4V 
可充锂电
2000
流明 / 
1
小时50分钟;
600
流明 / 9小时
120
流明
/46
小时
30分钟
暴闪,10赫兹
129600 
坎德拉
720 
1.5
IPX6
背带环
两个金属环, 分别位于头部与尾部,金黄色电镀
筒身滚花
人体工程学防滑滚花
2000 lm
 / 
1h50min; 600lm
/
9hrs30min; 120lm/46 hrs
1.Striking bezel
2.Lens
3.LED
4. Front strap ring
5. Head
6.Power switch
7.Battery pack
1. 
攻击头
2. 
透镜
3 . 
发光二极管
4. 
前背带环
5 . 
头部
6. 
电源按键
7. 
电池包
8. 
后背带环
9. 
尾盖
10
电源/电量指示灯
11 
充电口及软塞
12. 
电量指示开关
8.Rear strap ring
9. Tail-cap
10.Power indicator switch
11.Charging Socket and
      Weather-resistant plug
12.Power indicators
 Characteristics
 Specification
关机状态下, 按下开关按键并保持1秒或以上, 按下时开,释放时关 。
按下开关按键并在1秒内释放。每次开机,手电输出在前次关机时的亮度级。
开机状态下,按住开关键并保持,手电输出亮度在"低-中-高"之间循环,释放时保持选择  
的亮度。
快速连按开关按键二次(初始状态为关需按三次)。在暴闪状态下,按下开关,1秒内释 
放,输出关闭;如超出1秒,退出暴闪,返回常亮度模式。
开机状态下,按下开关键并保持,输出经历 “低-中-高”循环三次后自动关闭,手电进入
锁定状态;进入锁定状态后,按键临时失效(除了指定的解锁操作)。
在锁定状态,需快速连击按键三次解锁并开机。取下电池约30秒,再装入电池也会自动解
锁。
连接充电器到电源插板或墙壁插孔, 揭开手电尾盖充电接口软塞,将充电器DC插头插入进
行充电。 
充电状态指示灯位于充电器。 指示灯显示状态:红色 -- 充电进行中; 绿色 -- 充电完成
或未连接手电。充电完成后,请拔出DC插头,随手塞紧充电接口软塞, 防止有异物进入手
电;并将充电器从电源插板或墙壁插孔取下。 
轻按尾部的电量指示开关。4个绿色的指示灯指示电池大约剩余电量。四个灯全亮表示高电
量,亮灯数量越少,表示电池剩佘越低;如所有指示灯均不亮,表示电池能量将耗尽,需
要给予充电。
充电完成后,请及时断开电源,勿将充电器长时间连接到电源。不充电时,请勿将 手电长
时间连接到充电器。
瞬时点亮:
开、关机:
改变模式:
暴       闪: 
锁 按 键: 
解       锁:
充      电 :
显示电量: 
         
注意