TP-LINK 16-Port Gigabit Desktop/Rackmount Switch TL-SG1016D Data Sheet

08

Gigabit Unmanaged Switch

■

To install the device on the desktop, please follow the steps:

Set the device on a flat surface strong enough to support the entire weight of the 

1. 

device with all fittings.

Remove the adhesive backing papers from the rubber feet.

2. 

Turnover the device and attach the supplied rubber feet to the recessed areas on 

3. 

the bottom at each corner of the device.

Feet
Bottom of the Device

Notch

Desktop Installation

Figure 2-1 

■

To install the device in an EIA standard-sized, 1F-inch rack, follow the instructions 
described below:

Check the grounding and stability of the rack.

1. 

Secure the supplied rack-mounting brackets to each side of the device with supplied 

2. 

screws, as illustrated in the following figure.

Rack-mounting Bracket

Screw

Bracket Installation

Figure 2-2 

After the brackets are attached to the device, use suitable screws (not provided1 to 

3. 

secure the brackets to the rack, as illustrated in the following figure.

Installation