Kathrein 20210165 Data Sheet

23

DiSEqC™ Repeat:

The setting for how often the DiSEqC™ command must be repeated depends on the confi guration  of 
your reception system. Refer to the documentation for your reception system or seek assistance from a 
specialist engineer.

-  Off 

 

 

DiSEqC™ command is not repeated

-  1 

 

 

DiSEqC™ command is repeated once

-  2 

 

 

DiSEqC™ command is repeated twice

-  3 

 

 

DiSEqC™ command is repeated three times

SatPos

Select the fi eld “SatPos”. Set the “SatPos” here to match the confi guration of your reception system. 
You can select “Off” or a value from “1” to “4” in single unit increments.

Test Transponder:

Select the “Test Transponder” fi eld. Here you can select a transponder for checking whether your settings 
are correct using the signal strength bar and signal quality bar.

When you have completed all settings for this satellite, press the 



 (green) button.

If you have selected more than one satellite (max. 64) for Tuner 1, the receiver will automatically skip 
to the settings for the second satellite. Now defi ne the settings for the second satellite, followed by the 
other selected satellites, in the same way as described for the fi rst satellite.

Once all settings for all the satellites that you selected have been completed, the receiver will 
automatically skip to the settings for the second tuner (assuming that for the second tuner you selected 
the connection type “Separated” and set the signal confi guration to “Different from Tuner 1”). If this is the 
case, now defi ne the settings for the second tuner in the same way as you did for the fi rst tuner.

Once you have completed the settings for both tuners and the satellites assigned to them, the receiver 
will automatically display the screen for the channel search. Continue the fi rst installation with the 
“Channel Search” section.