Danalock Smart lock Bluetooth-version 831957 Data Sheet

Schnellanleitung EURO-Version

Remove  the  old  thumb  turn  on  your 

door,  but  please  keep  the  screws  that 

held it for later use.

In the box you will find 2 tailpiece 

extenders  for  flat  and  square 

tailpieces, making your danalock 

fit most deadbolts.

Now  fasten  the  baseplate 

with the screws that original

ly  held  the  thumb  turn  and 

cylinder piece.

Important! The cylinder tailpiece have to align with the 

door surface. Extend the tailpiece with one of the two 

extenders before you mount the baseplate. The tailpiece 

extender should stick out 10 mm from the baseplate.

Click the lid off your danalock with your 

nails, or loosen the lid by gently turning 

a screwdriver in the slot at the rim of 

the shell. 

Place  your  danalock  on  the  base,  be 

sure  the  cylinder  tailpiece  fits  in  the 

center.

Fasten the 3 base-screws.

Click the lid back on. Now Your 

danalock is now ready for use.

10 mm

align with 

the door 

surface

The danalock comes with batteries inserted, but a thin plastic folio 

guarantee that your new danalock is fully charged. Remove the folio 

and the danalock lits up with a green light for 5-10 seconds.

Loosen the 3 base-screws placed right underneath the 

printed circuit board with a screwdriver.