Buffalo LinkStation 441D 12TB LS441D1204-EU Data Sheet

80

Tap Apply, then OK.

The USB device server lets you use USB devices connected to the LinkStation with multiple computers.

Connect the USB device directly to your computer and install its drivers and software normally.
Dismount and remove the USB device when installation is complete.

Connect the USB device to the LinkStation's USB port.

Note: With the USB device server enabled, you may connect a single USB hub to the LinkStation. Up to 15 
USB devices may be connected to the hub. Don't connect more than one bus-powered drive at a time. Use a 
separate AC power connection for each device if possible. Connecting more than one bus-powered device at a 
time may damage both the LinkStation and the devices.

In Advanced Settings, click File Sharing.

Click 

 to the right of "Folder Setup".

Select the USB device connected to the LinkStation.

Note: USB device server and DLNA are not compatible. Disable DLNA protocol support if using USB device 
server.

Move the USB device server switch to the 

 position to enable the USB device server.

You can also enable the USB device server from Easy Admin.

Note: When the USB device server is enabled, other functions that use the USB port won't be available.

To install Network-USB Navigator, click USB Device Server in Easy Admin or navigate to Services - USB Device 
Server - USB Device Server in Advanced Settings. You'll need administrator privileges to install the software.

Launch Network-USB Navigator.
For Windows:
Navigate to (All) Programs - BUFFALO - Network-USB Server, then click Network-USB Navigator. On Windows 8.1 
or Windows 8, click Network-USB Navigator from the Start screen.
For Mac: 
Navigate to Macintosh HD - Applications - BUFFALO - Device Server - Network-USB Navigator.