Renkforce 3D printer assembly kit RF1000 Single extruder (value.974113) RF1000 Data Sheet

Tip the printer onto its back close to the edge of the table and

remove the bottom sheet.
Attach the weight to the part of the toothed belt for the Z-direc-

tion that is now at the top with the cord.
The weight must be suspended to be freely movable but may

touch the mains unit housing. This is not a problem.

Measure the distance between the two toothed belt halves as

shown in the figure. Set a distance of 41 mm with the belt ten-

sioner.