Tripp Lite 2-2.4kW Single-Phase Hot-Swap PDU, 200-240V 10A Outlets (8-C13), 2-C14, 200-240V Input, 6ft Cords 2U Rack-Mount PDUBHV10 Data Sheet

MODEL NUMBER: PDUBHV10

 

 

Tripp Lite’s Hot-swap PDU systems enable live-replacement of standard UPS systems for maintenance with no

interruption of connected server or networking loads. Dual input power cables support PDU connection to

separate Utility and UPS power sources. Manual transfer switch with lighted status indicators controls the source

of power to connected equipment between Utility and UPS. Set the switch to UPS during normal operation and

connected equipment will receive full-time conditioned power from the UPS. Set the switch to Utility to

momentarily power connected equipment from the Utility line cord and bypass the UPS while the UPS system is

removed and replaced with a fresh one. Once the new UPS is up and running with all data and electrical

connections restored, set the switch back to the UPS setting to once again provide fully-conditioned UPS power

to connected equipment. 

Tripp Lite Hot-swap PDU systems support live-replacement of standard UPS systems for maintenance with

no interruption of connected server or networking loads

PDUBHV10 is universally compatible with any Tripp Lite or other brand of 200-240V UPS rated up to 1500VA with a C14 input cable option

2U horizontal rackmount form factor compatible with 2 or 4 post racks

Supports space saving rear-post mounting in the same rack space as many Tripp Lite Rackmount UPS systems (select installations, see manual)

Pair of detachable PDU input cables connect to separate Utility and UPS power sources (2 C13-C14 interconnect cables included - user supplied

alternate cabling supported)

8 C13 outlets support critical networking loads in both Utility and UPS operating modes

One additional C13 pass-through outlet supports UPS input power cord

Dual input power cables support PDU connection to separate Utility and UPS power sources

Manual transfer switch with lighted status indicators controls the source of power to connected equipment between Utility and UPS

Set the switch to UPS during normal operation and connected equipment will receive full-time conditioned power from the UPS

Set the switch to Utility to bypass the UPS and provide connected equipment with unfiltered power directly from the Utility line cord while the UPS system

Single phase 10A 200-240V

Hot-swap PDU

Enables live replacement of a

standard UPS with zero downtime

2U horizontal rackmount

installation

Compatible with any 200-240V

UPS with a C14 input 

Manual transfer switch controls

PDU input power source

Pair of C14 compatible inputs

connect to separate Utility and

UPS inputs

8 Built-in C13 outlets 

Hot-swap PDUs are ideal to install

along with standard UPS systems to

ensure that connected networking

equipment will see no power

interruption as the UPS is serviced,

replaced or upgraded

Hot-swap PDU System

2U mounting brackets

Set of 2 C13-C14 interconnect

cables

User manual with warranty

information

1 / 3