Intel E5-1428L CM8062001144000 Data Sheet

52

1.31

75

1.66

98

2.01

BB

2.36

DE

2.71

53

1.320

76

1.67

99

2.02

BC

2.37

DF

2.72

54

1.33

77

1.68

9A

2.03

BD

2.38

E0

2.73

Note: 
1. 00h = Off State
2. VID Range HEX 01-32 are not used by the Intel

®

 Xeon

®

 processor E5-1600 and E5-2600 v3 product

families

3. For VID Ranges supported see 

on page 31

4. V

CCD

 is a fixed voltage of 1.20V

All Reserved (RSVD) signals must not be connected. Connection of these signals to

V

CCIN

, V

CCD

, V

SS

, or to any other signal (including each other) can result in component

malfunction or incompatibility with future processors.

For reliable operation, always connect unused inputs or bi-directional signals to an

appropriate signal level. Unused active high inputs should be connected through a

resistor to ground (V

SS

). Unused outputs maybe left unconnected; however, this may

interfere with some Test Access Port (TAP) functions, complicate debug probing, and

prevent boundary scan testing. A resistor must be used when tying bi-directional

signals to power or ground. When tying any signal to power or ground, a resistor will

also allow for system testability. Resistor values should be within ± 20% of the

impedance of the baseboard trace.

All Reserved (RSVD) signals must not be connected. Connection of these signals to

V

CCIN

, V

CCD

, V

SS

, or to any other signal (including each other) can result in component

malfunction or incompatibility with future processors.

For reliable operation, always connect unused inputs or bi-directional signals to an

appropriate signal level. Unused active high inputs should be connected through a

resistor to ground (V

SS

). Unused outputs maybe left unconnected; however, this may

interfere with some Test Access Port (TAP) functions, complicate debug probing, and

prevent boundary scan testing. A resistor must be used when tying bi-directional

signals to power or ground. When tying any signal to power or ground, a resistor will

also allow for system testability. Resistor values should be within ± 20% of the

impedance of the baseboard trace.

Signals are grouped by buffer type and similar characteristics as listed in the following

table. The buffer type indicates which signaling technology and specifications apply to

the signals.

Intel

®

 Xeon

®

 Processor E5-1600 and E5-2600 v3 Product Families, Volume 1 of 2, Electrical

Datasheet

September 2014

22

Order No.: 330783-001