EGig GigE Triple Play PIM PIM 415/D-GigE Leaflet

GigE Triple Play PIM

Platform Interface Module

Specification Sheet

March 2008

PIM 41S/D-GigE

Page 1 of 2

GigE Triple Play PIM

BERT, IP QoS, RFC2544, Monitor, Service Tool and NIC for 

Triple Play Analysis Suite–IPTV, VoIP, Data

Configurable Speed, Duplex, Flow Control (Auto/Manual), 

and Remote Loop back L1/L2/L3

IP V4 or IP V6

Source/Destination MAC/IP and VLAN addresses with    

traffic load averaged

Addresses, Prioritization/IP header, Frame size, 

Payload, Traffic load

BER count/BER %, Frame sync loss count/time, 

Pattern Sync Loss time, BER frames received, 

Utilization% and FPS

CRC error count/rate, IP checksum error count/rate, 

Packet loss, Sequence error, Alignment, Line-rate

EtherType II (DIX v.2)

IEEE 802.3–LLC1 and IEEE 802.3–SNAP

Layer 1, MAC, MAC+IP, MAC+IP+UDP

Up to 256 multi-streams per port in Uniform Traffic Profile

  -

Up to 4 multi-streams per port in Individual Traffic Profile

  -

Source/Destination MAC/IP and VLAN ID (Single/Stack 

Q-In-Q), ARP/DHCP supported

VLAN ID (802.1Q)/Priority (801.p), and IP TOS/Cisco 

DiffServ DSCP

Prioritization, TTL, UDP/TCP/HOPOPT

Up to full wire speed in Line Utilization %, Line Rate in 

Kbps, Frame Rate in FPS and Frame Gap

64~2040 Bytes, including Under/Oversize and Jumbo

Infinite, the Number of Frames, and Timed

Single or Dual 10/100/1000Base-T Electrical UTP (RJ-45) 

and 1000Base-X Optical (SFP) port

IEEE 802.3 2005 Compliance

Module: On or Off

IF/LB: SFP (Optical), UTP (Copper) or loop back

Link: Signal or Loss (SFP), Link Up or Down (UTP)

Speed: 1G (SFP), 10M, 100M or 1000M (UTP)

Sync: Pattern Sync/Loss (BER) or Error

Laser: Laser On or Off

PRBS, CJPAT, CRPAT, All-0s, All-1s, ALT1/0

Constant, Ramp and Burst

BE (BERT), CRC, IP Checksum and Alignment

IP QoS test in asymmetric or symmetrical testing 

Remote Loop back with MAC/IP S/D addresses swapped 

automatically

Single BERT with Uniform multi-streams in P-t-P, P-t-LB

Multi-BERTs with Individual multi-streams in P-t-P, P-t-MP 

and P-t-LB

BER Testing in Asymmetrical or Symmetrical testing 

Loop back with MAC/IP source/destination addresses 

swapped automatically

Same as the traffic statistics–Physical and Frame layer in 

Monitor mode

Individual Stream-based :

Port-based :

2

15

-1, 2

20

-1, 2

23

-1, and 2

31

-1, with pattern inverted option

Long Continuous Random Test Pattern (CRPAT)

Long Continuous Jitter Test Pattern (CJPAT)

All-0s, All-1s, ALT1/0

Anacise QoS Test Payload with sequence no. and timing 

inserted for the validation of Triple Play service

Same as the traffic statistics–Physical and Frame layer in 

Monitor mode

40 ns for all timing parameter measurements

Network Delay in ms (Current, Min, Max, and Avg) 

Inter-Arrival Time (Current, Min, Max, and Avg) 

Jitter Distribution Analysis Diagram

Packet Loss (Count, Ratio)

Out of Sequence (Count, Ratio) 

QoS result is classified per the standard of ITU-T Y.1541 

Network Performance Objectives for IP-Based Service

2

15

-1, 2

20

-1, 2

23

-1, and 2

31

-1, with pattern inverted option

Single Port A (Term./LB, Monitor)

Single Port B (Term./LB, Monitor)

Dual Port A and Port B (Term./LB, Mon, PassThrough)

Port in Electrical or Optical