Smarthome Thermostat 2491T1E Leaflet

Rev. 6/27/2011 11:29 AM /   See Owners Manual for Warranty Information, Patented 
© Copyright 2011, Smarthome, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845 

 

 

  
 
 

 

 

 
 

 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Follow directions in the Venstar thermostat owner's manual. Installation should be 
performed only by qualified electrician o

owner.

r expert home

 

1)  Press & hold the Scene Controller button until it beeps

*

 

 

2)  Adjust Thermostat to desired scene settings/modes/etc. 

3)  If you wish to link to “scene Off” – Double-Tap Thermostat’s Set Button, 

otherwise proceed to step 4 

4)  Press & hold Thermostat’s Set button  

 

5)  Confirm that Scene addition was successful by tapping sending an “on” 

(and/or off) from the controller’s scene button 

 

 

Owner’s Manual: 

 - Phone: 800-762-7845 

*

Most products

 

Mode Button 

Status LED 

INSTEON LED 

Set Button 

1)  Activate the Desired Controller Mode 

a.  A/C – Turns Responders on when A/C begins cooling and off when A/C ends cooling 

-  Tap Thermostat mode button until only cool set point is displayed 

b.  Heat - Turns Responders on when Heating begins and off when Heating ends 

-  Tap Thermostat mode button until only heat set point is displayed 

c.  Fan – Turns Responders on when the fan is turned on via INSTEON or when the thermostat turns fan on 

via timer or when the user sets fan to always on mode (and off when the reverse happens) 

-  Open Thermostat door and Tap the Fan button until “FanOn” is displayed on the LCD 

2)  Press & hold Thermostat’s INSTEON Set button until LCD screen flashes 

3)  On the Responder, adjust it to the desired scene state

*

 

4)  Press & hold the Responder’s Set button until it beeps

*

 (or until LED flashes) 

 

5)  Confirm that Scene addition was successful by adjusting the Thermostat to the Mode you defined above