ONKYO TA-6711 User Manual

5

• Do not plug in the power cord until all connections have been made.
• On each pair of input or output jacks, the lower jack (marked R) corresponds to the right channel, and the upper jack (marked L) to

the left channel. Also refer to the amplifier's instruction manual for further information on connections.

Connect the tape deck LINE IN jacks to the
TAPE REC jacks on the rear panel of the
amplifier and the tape deck LINE OUT
jacks to the amplifier TAPE PLAY jacks.
Also refer to the amplifier's instruction
manual for further information on connec-
tions.

1. Plug the AC power cord into a wall

outlet.

2. When you press the POWER button,

the indicator and the display will light
up.

If the TA-6711 is properly connected to another Onkyo component bearing the z mark, you will be able to control the TA-6711 using
the other component's remote control.

The upper and lower remote control jacks
have the same function.
For remote control operation, connect this
jack and any Onkyo amplifier, receiver or
CD player bearing the z mark using the
remote control cable.
Note:
Do not attempt to connect the z remote
control jack to any equipment other than an
Onkyo component bearing the z mark.
Doing so could cause the unit to malfunc-
tion.

The functions listed below can be accom-
plished using the remote control of the
master unit.

s

:Play

f :Fast forward
d :Rewind
e

:Stop

t

:Rec/pause

Once connections are made as shown at
left, this function becomes operational. It
automatically starts recording on the
cassette deck when the s button of the
CD player is pressed. (See page 12.)

LINE IN     LINE OUT

  (REC)        (PLAY)    

L

R

TAPE

L

L

R

R

(REC)

(PLAY)

•

•

-

-

•

WARNING

®

AVIS