Telular SX4e TDMA User Manual
SX4e TDMA 800 • SX4e Tri-Mode
5
Technical Manual
Connect Your SX4e to AC Power
1) A protective earth (safety ground) terminal
(screw) marked with this protective earth
symbol is provided on the back of the SX4e
Phonecell unit. Connect this terminal to a
good earth ground (i.e., a cold water pipe)
by means of an 18 gauge or heavier insu-
lated wire. The wire insulation should be
green with a yellow stripe to indicate that
this is a protective earth (safety ground)
connection - see Figure 5.
symbol is provided on the back of the SX4e
Phonecell unit. Connect this terminal to a
good earth ground (i.e., a cold water pipe)
by means of an 18 gauge or heavier insu-
lated wire. The wire insulation should be
green with a yellow stripe to indicate that
this is a protective earth (safety ground)
connection - see Figure 5.
2) Connect the Line Cord from the AC power
source to the Power Supply.
3) Connect the barrel plug on the Power Supply to the Power Input port marked “DC Input”, on the
side of the SX4e.
NOTE: An optional battery back up unit (not supplied) may be used instead of the Power Supply
- see Figure 6. Follow the battery installation instructions provided with the Backup Unit.
NOTE: An optional battery back up unit (not supplied) may be used instead of the Power Supply
- see Figure 6. Follow the battery installation instructions provided with the Backup Unit.
4) The LED Power Status indicator (located on the front of the FWT) will turn green immediately
upon connecting to power.
Figure 5 - Protective earth terminal screw.
Protective earth
(safety ground)
terminal screw
Power “DC
INPUT” Port
AC Power
Line Cord
●
●
●
Optional Battery
Backup Unit
Power
Supply
Figure 6 - Connect the SX4e to power.