Vortech Engineering Supercharger System 4NT020-010 User Manual

If your vehicle has gone over 20,000 miles
since its last spark plug change, it is a good
idea to change the spark plugs now, before
test-driving.

Make sure that oil drain to oil pan fitting is
tight and that the engine is filled with factory
specified oil.

Make sure radiator and overflow tanks are
filled with a 50/50 coolant/water mix.

Make sure that the vehicle is filled with 91
octane or higher fuel before commencing a
test drive.

Turn the key ON and OFF several times to
build fuel pressure. Check for fuel leaks
(especially around the fuel injectors).

With the key on, make sure the charge air
cooler water pump is operating and that
water is flowing through the surge tank. Fill as
necessary. If water is not flowing, remove the
hose from the bottom of the surge tank and
lower until water flows out of hose. This
should prime the pump. Reconnect hose, ver-
ify water flow and top off surge tank. Do not
run the water pump for extended periods (30
seconds or more) without water flow.

Check all fittings, nuts, bolts and clamps for
tightness.

At this point it is OK to start the vehicle.

Turn off the vehicle and recheck all fluid lev-
els and verify that no hoses, wires, etc. are
near exhaust headers or moving parts and
that there is no fluid leakage.

Test drive the vehicle by gradually working up
to full throttle and paying close attention to
any abnormal sounds or engine detonation.

Read the STREET SUPERCHARGER SYS-
TEM OWNER’S MANUAL AND RETURN
THE WARRANTY REGISTRATION FORM
within thirty (30) days of purchasing your
supercharger system to qualify for the 3-year
limited warranty.