Sharper Image IB-ECB130 User Manual

•  Indoor & Outdoor Temperature Display
•  Male voice announces time reporting and alarm mode
•  Easy-to-read display with illuminated LCD/3-level white backlight (HI/MED/LO)
•  AM/FM Digital Radio tuning with 8 preset memory
•  Dual Alarm Clock – 3 Wake Modes: Radio, Beep Tone or Male voice (report

looping)

•  Convenient Snooze/Nap function
•  Digital Volume: 1-8 level
•  Speaker: 3” diameter
•  Operation temperature: +32° F to +122° F (0° C to + 50° C)
•  Indoor temperature range: +32° F to +122° F (0° C to + 50° C)
•  Operating frequency: 434 MHz
•  Maximum Transmission distance: 100 feet (30 meters)
•  Power adaptor: 120 Vac input 6 Vdc 300 mA output
•  Back-up battery: CR2032 (included)

5

4

Fig. 1

EC-B130_Clock Radio Weather ButlPage 1   7/6/09   4:50:10 PM

•  Outdoor temperature range: -4° F to +140° F (-20° C to +60° C)
•  Operating frequency: 434MHz
•  Maximum Transmission distance: 100 feet (30 meters)
•  Battery power: 2xAAA (not included))

1. Remove battery compartment cover on the bottom of the unit.  Insert one 

included CR2032 battery into the unit according to the polarity direction 
indicated. Replace cover and snap into place.

2. Attach the DC end of the adaptor into the DC jack on the base of the unit and 

insert the AC plug into a 120 VAC outlet.

NOTE: In the event of a power outage the battery is designed to provide memory 
back-up for the clock  radio settings and alarm settings.  The time will not be 
illuminated on the clock display when there is no AC power available.  As soon as 
the power supply returns, the display will indicate the correct time.
NOTE: To hold the time, radio settings and alarm time the back-up battery must 
be installed.

1. Loosen the 4 screws securing the battery cover with a small screwdriver

(included) and remove.

2. Insert 2xAAA alkaline batteries according to the polarity direction indicated.
3. Place the home receiver (Clock Radio Time & Weather Butler) as close as

possible to the remote sensor. This will help with synchronization between the 
two units.

4. The remote sensor is preset to °F. Press the ˚C/˚F button inside the remote

sensor to change between °C and °F.

5. Press the TX button inside of the remote sensor to verify the reception.
6. Replace the cover and tighten the 4 screws.
NOTE: It is recommended to first test the units next to each other to ensure that 
both the remote sensor and home receiver are properly synchronized.