HP Performance Optimized Data Center (POD) 40c Quick Setup Guide
Site plan requirements and actions 25
•
Assembly equipment locations
HP POD 40c G2 lifting requirements
WARNING:
The only approved method for lifting the HP POD 40c G2 is the use of a spreader
bar harness. Lifting an HP POD 40c G2 in any other manner can cause damage to the HP POD
40c G2 and void your warranty.
40c G2 and void your warranty.
HP POD 40c G2 storage requirements
If the site is not ready for assembly and operation, determine a location for storage when creating the site
plan.
plan.
CAUTION:
The HP POD 40c G2 must maintain 20% relative humidity to minimize condensation
and oxidation within the HP POD 40c G2.
CAUTION:
While being stored, the HP POD 40c G2 must be kept in a level position even if
stored on a trailer.
Changes in ambient temperatures can cause condensation in a non-operational HP POD 40c G2. If the HP
POD 40c G2 is placed in storage or is in non-operating mode for over 72 hours, HP recommends using one
of the following methods to minimize condensation and oxidation within the HP POD 40c G2:
of the following methods to minimize condensation and oxidation within the HP POD 40c G2:
•
Desiccant unit
•
Desiccant material
•
Heater with a fan
•
Air conditioner with a heater strip
Consult with HP Services to determine the most effective method.
Additional structures
If a customer-provided vestibule or other structure is installed and connected to the HP POD 40c G2, the
following specifications must be maintained:
•
To protect the HP POD 40c G2 and ensure a waterproof barrier, flashing must be installed to the
exterior of the HP POD 40c G2 in the location where the other structure is attached.