ADT Security Services EZ User Manual
18
SYSTEM TROUBLE ERROR CODES
TBL
Flashes /
Touchpad beeps
READY
Flashes
Trouble Condition
Action
6
NONE Lost Key Mode
This is a reminder that the system has been put into the lost key mode ([STAY] &
[AWAY] pressed simultaneously). While in this mode, the system can only be dis-
armed with your EZ-IFOB. When you have replaced or re-keyed your deadbolt,
press [STAY] & [AWAY] simultaneously again to exit lost key mode.
[AWAY] pressed simultaneously). While in this mode, the system can only be dis-
armed with your EZ-IFOB. When you have replaced or re-keyed your deadbolt,
press [STAY] & [AWAY] simultaneously again to exit lost key mode.
7
NONE Fire Zone Trouble
A problem has been detected with the Fire zone. Call for service.
1
1
Wireless Receiver TBL
or EZ Touchpad TBL
or EZ Touchpad TBL
A problem has been detected with the wireless receiver. Call for service.
2
2
Wireless Receiver Jam A problem has been detected with a wireless receiver. Call for service.
3 2-8
Wireless
Transmitter
Low Battery
The battery in a wireless transmitter is low and should be replaced. This transmit-
ter is on the zone corresponding to the number of
ter is on the zone corresponding to the number of
READY
flashes. The replace-
ment battery for the GEM-TRANS2 door/window transmitter, GEM-PIR motion
detector and GEM-GB glass break detector is the Duracell DL123A 3 Volt Lithium
(2 required for the GEM-PIR and GEM-GB). The GEM-DT Dual Technology Sen-
sor requires 4 C cell Alkaline batteries.
detector and GEM-GB glass break detector is the Duracell DL123A 3 Volt Lithium
(2 required for the GEM-PIR and GEM-GB). The GEM-DT Dual Technology Sen-
sor requires 4 C cell Alkaline batteries.
Warning: Replace batteries only with the same
type as specified above. Use of another battery may present a risk of fire or explosion. Do
not recharge or disassemble battery, or dispose of in fire.
not recharge or disassemble battery, or dispose of in fire.
4 2-8
Wireless
Transmitter
Supervisory Failure
A problem has been detected with a wireless transmitter on the zone correspond-
ing to the number of
ing to the number of
READY
flashes. Call for service.
5
1-4
Wireless Smoke
Detector Low Battery
Detector Low Battery
The battery in a wireless smoke detector is low and should be replaced. The
number of the smoke detector corresponds to the number
number of the smoke detector corresponds to the number
READY
flashes. The
replacement battery is the Duracell MN1604 9 Volt Alkaline (2 required).
Warning: Replace batteries only with the same type as specified above. Use of another
battery may present a risk of fire or explosion. Do not recharge, disassemble, or dispose of
battery in a fire.
battery may present a risk of fire or explosion. Do not recharge, disassemble, or dispose of
battery in a fire.
6
1-4
Wireless Smoke
Detector Supervisory
Detector Supervisory
A problem has been detected with a wireless smoke detector. Call for service.