Cardo SCALA RIDER G4 User Manual

2. CONTENTS OF THE RETAIL BOX

2 Helmet clamps (subject to the version purchased: Boom-Mounted or

Cord-Mounted Microphone)

Two speakers

Noise

canceling

microphone

Flexible Boom

2 scala rider G4

headsets

Flip-up

antenna

Channel A

Button

• Connect to

Rider A

• MP3 Button

Channel B Button

• Connect to Rider B

• FM Radio Button

Mobile

Phone

Button

Volume Up /

Forward

Button

Volume

Down /

Rewind

Button

Charging Jack

& Firmware

download port

2 Wall charger plugs
2 USB adapter cables
2 Allen wrenches
4 Velcro pads
2 MP3 cables
2 Glue plates
2 Pre-moistened towlettes
2 Carry pouches
4 Microphone sponges

Flat sponges for full-face helmets and round sponges for other helmet types
User Guide, stickers, Warranty and Registration form

The scala rider G4 is also available in a cord-mounted microphone

version to better fit certain full-faced helmets with tight chin sections

IMPORTANT:

Your headsets are water-resistant, designed for use under moderate rain or

snow conditions. The cover lid protecting the Charging Jack should be kept

tightly closed at all times to prevent moisture from entering the device.

NOTE: WHILE MOST INSTRUCTIONS ON THIS MANUAL REFER TO THE HEADSET

IN SINGULAR, THEY APPLY TO BOTH UNITS UNLESS INDICATED OTHERWISE

3. CHARGING THE HEADSET

Make sure that your headset is fully charged for at least four hours

before initial use. Open the silicone cover protecting the Charging

jack and Firmware download port.

Insert the USB cable to the wall charger and insert

the other end of the cable to the headset’s

Charging Jack. While charging, the Red Light turns

on. When charging is complete, the Red Light will

turn off.

Sliding Panel

Silicone cover

LED

MP3 Jack

(back of clamp)

scala rider

™

PowerSet