Oregon Scientific EMR211 User Manual
EN
3
REMOTE SENSOR (THN132N)
1
2
3
4
5
5
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4.
2. Wall mount hole
3. Battery compartment
4.
RESET hole
5.
CHANNEL switch
REFERENCE Other supported sensors include models:
THGN328N, THGR328N, BTH sensor, THN318N.
GETTING STARTED
INSERT BATTERIES
INSERT BATTERIES
1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (
2. Insert the batteries, matching the polarities (
+/-).
3. Press
RESET after each battery change.
LOCATION
MEANING
Outdoor temperature area
Outdoor sensor batteries low
Indoor temperature area
Indoor sensor batteries
low / main unit batteries low
REMOTE SENSOR
The main unit can collect data from up to 5 sensors.
To set up the sensor:
To set up the sensor:
1. Open the battery compartment.
2. Select a channel then press
2. Select a channel then press
RESET.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main unit
4. Place the sensor within 98 ft (30 m) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 5 ft (1.5 m); and can shield it from direct
sunlight or wet conditions for an accurate reading.
1.5 m (5 ft)