Verbatim Computer Hardware K7VT4-4X User Manual

1 3

2.7 Jumpers Setup

The illustration shows how jumpers are

setup. When the jumper cap is placed on

pins, the jumper is “SHORT”. If no jumper

cap is placed on the pins, the jumper is

“OPEN”. The illustration shows a 3-pin

jumper whose pin1 and pin2 are “SHORT”

when jumper cap is placed on these 2 pins.

J u m p e r

Setting

FSB_SEL0

(see p.7/p.8  item 10)

Note: The setting of the CPU front side bus frequency of this motherboard is by

means of the adjustment of jumper-setting. Please follow the figures above

to set the CPU front side bus frequency.

 PS2_USB_PWR1

Short pin2, pin3 to enable

(see p.7/p.8 item 1)

+5VSB (standby) for PS/2 or

USB wake up events.

Note: To select +5VSB, it requires 2 Amp and higher standby current provided by

power supply.

JR1

(see p.7/p.8 item 26)

JL1

(see p.7/p.8 item 25)

Note: When you connect speakers in back panel and front panel at the same time,

1. If the jumpers JL1 and JR1 are short (see fig. 1), both front panel and

rear panel audio connectors can work.

2. If both jumper caps on JL1 and JR1 are removed (see fig. 2), only front

panel audio works.

However, it requires your front panel to support the function.

JR1

JL1

JR1

JL1

fig. 1

fig. 2

FSB 200MHz

FSB_SEL0

FSB_SEL0

FSB 266MHz

FSB 333MHz

FSB_SEL0