Kentrox AI296 User Manual

AI296 Version 9.8x User’s Guide

AI296 Commands: diag-line

Tip: Press ENTER to execute a command and press ESC to end the diagnostic 

session.

CAUTION: If you are connected to AI296 through a serial port, do not monitor the 

port with command 

diag-line

. Use command 

hide

 to hide and not 

monitor the port. Failure to comply with this statement can cause AI296 
to become unresponsive.

shell

diag-line

interpret [ a | x ]

Toggles the display of decoded packet data on the line 
monitor on or off and optionally selects the format of the data 
in the data portion of the packet (

a

 or 

x

).

z

a

 displays the data in the data portion of the packet in 

ASCII/hexadecimal format. Unprintable data 
(hexadecimal values 0x00 to 0x20 and 0x7F to 0xFF) 
appears as two digit hexadecimal numbers separated by 
a space. Printable data appears as printable characters. 
This option only applies to data.

z

x

 displays all the data in the data portion of the packet in 

hexadecimal format. All data appears as two-digit 
hexadecimal numbers separated by a space. This option 
only applies to data.

print

Prints the range of revealed LCNs for all lines.

CTRL+

s

Pauses the line monitor.

go

 or CTRL+

q

Reactivates the line monitor after displaying the line monitor 
options.

ESC or 

q

Quits monitoring traffic, exits from the line monitor, and 
returns to the prompt.

?

Displays a list of the options available for line monitoring 
diagnostics.

Table 9-2   Line Monitor Mode Options (Continued)