Buffalo Technology LinkStation LSV40TL User Manual

LinkStation User Manual

160

Appendix

E01

Problem in DRAM DATA LINE. Contact Buffalo tech support for assistance.

E02

Problem in DRAM ADDRESS LINE. Contact Buffalo tech support for assistance.

E03

Problem in RTC CHIP. Contact Buffalo tech support for assistance.

E04

Kernel extraction failed. Contact Buffalo tech support for assistance.

E06

The firmware is corrupted. Contact Buffalo tech support for assistance. Wait 5 minutes 
for “E04”, then shut down the unit.  Or, turn the power switch off.

E07

No hard drives detected. If the hard drives are connected normally, contact Buffalo 
technical support for assistance.

E10

Operating from UPS battery. The LinkStation will be shut down normally. After the 
LinkStation shuts down, ensure that power is supplied to the UPS. If there is no 
problem, briefly press the LinkStation’s function button to reset.  Do not hold down 
the function button too long or you may get unexpected results.

E11

Fan Error. The fan is spinning too slowly or has stopped.  Move the unit to a cool place 
with good airflow and no objects blocking the fan.  If the LED remains lit, replace the 
fan with part OP-FAN/LS, sold separately.

E15

Hard drive IO error. Contact Buffalo tech support for assistance.

E16

The hard disk is not connected or is malfunctioning. Contact Buffalo tech support for 
assistance.

E17

Internal controller error. Contact Buffalo tech support for assistance.

E20

The circuit board may be damaged.  Disconnect and then reconnect power.  Reboot 
the LinkStation. If the error persists, contact Buffalo technical support for assistance.

E21

Internal controller error. Contact Buffalo tech support for assistance.

E22

Drive mount error. Contact Buffalo technical support for assistance.

E23

The hard drive may be damaged. Contact Buffalo technical support for assistance.