Pelco Computer Keyboard C581M-B User Manual
30
Pelco Manual C581M-B (1/04)
7.
Turn activity boxes on or off (by default, all activity boxes are on).
To turn on all activity boxes, use the pan/tilt keys to choose SET ALL. Press the OPEN
key. All boxes will contain a symbol as shown in Figure 8. The multiplexer will monitor
motion in those boxes.
key. All boxes will contain a symbol as shown in Figure 8. The multiplexer will monitor
motion in those boxes.
To turn off all activity boxes, use the pan/tilt keys to choose CLEAR ALL. Press the
OPEN key. All boxes will be blank.
OPEN key. All boxes will be blank.
To turn on or off an individual box, use the pan/tilt keys to select the box. Press OPEN
key to toggle a box on or off.
key to toggle a box on or off.
Turn off activity boxes where you want motion ignored, such as blowing trees, high-
ways, computer monitors, fluorescent lighting, and non-problem areas. An example of
a non-problem area would be a camera focused on a bank vault entrance but ignoring
tellers working nearby.
ways, computer monitors, fluorescent lighting, and non-problem areas. An example of
a non-problem area would be a camera focused on a bank vault entrance but ignoring
tellers working nearby.
8.
To test the activity detection, highlight TEST and press the OPEN key.
Create motion in front of the camera. Small black and white dashes will flash where
motion is detected.
motion is detected.
To exit the test mode, press the OPEN key to return to the mask.
9.
If you did not like what you saw in the test mode, change the mask and test the activity
detection again.
detection again.
10. When you finish defining the activity detection mask, go to EXIT. Press the OPEN or
CLOSE key to exit the programming mode.
11. If necessary, repeat steps 1-10 to program the activity detection mask for other cameras.
SEQUENCE SETUP (SEQ Key)
Sequencing can be programmed in full screen, four-camera and nine-camera displays.
The cameras will not sequence when operating the zoom function. The LED(s) above the
camera button(s) on the multiplexer will illuminate to indicate which camera(s) is being
displayed.
The cameras will not sequence when operating the zoom function. The LED(s) above the
camera button(s) on the multiplexer will illuminate to indicate which camera(s) is being
displayed.
To program camera sequencing:
1.
Press the MAIN MONITOR key.
2.
Use the number keypad to enter the address of the multiplexer (1-16 if the keyboard is
connected to a multiplexer; 1-8 if the keyboard is connected to a server), then press
the UNIT key.
connected to a multiplexer; 1-8 if the keyboard is connected to a server), then press
the UNIT key.
3.
Press the SEQ key for approximately three seconds. Type the password, if requested.
The Sequence menu appears. The currently selected menu item blinks.
The Sequence menu appears. The currently selected menu item blinks.
4.
Use the pan/tilt keys to move between items on the screen. When the menu item you
desire is highlighted (blinking), press the OPEN key to cycle through the options to
select the one you want.
desire is highlighted (blinking), press the OPEN key to cycle through the options to
select the one you want.
5.
When you have completed all the changes you want to make, go to EXIT.
6.
Press the OPEN key to exit the programming mode.
When HELP is highlighted, you may press the OPEN key to display a help screen that will
tell you which keys to press to configure specific options.
tell you which keys to press to configure specific options.