DKS Enterprises PC Compatible Multi-Door Access Controller 1838 User Manual
3.4 PROGRAMMING PHONE NUMBER
NOTE: These programming steps are only used when a DKS 1838-120 or 1838-121 Remote
Call Station is connected to the 1838 system.
Call Station is connected to the 1838 system.
3.4.1
Programming the Directory Code Length
This programming sequence sets the directory code length to 1 - 2 - 3 or 4 digits.
Factory setting is three (3) digits.
CAUTION: This programming sequence will delete all directory codes that have been
previously programmed into the system.
previously programmed into the system.
1. Press
* 2 0 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the desired directory code length _ (1, 2, 3 or 4) then press * (beep).
3. Enter
0 then * to cancel this command or enter 1 then * to confirm this command. A long
tone (beeeeeep) will sound when the programming is complete.
3.4.2
Programming 7-digit Phone Number
In this programming sequence, the directory code and 7-digit phone number will be programmed into
the system. Be sure you have programmed the directory code length that you desire as described in
3.4.1. Changing the directory code length after programming the telephone number will erase
all the numbers and directory codes that have been programmed. To program a phone number
that will be referenced to an area code (long distance calls and 10 digit calling), follow the instructions
under 3.4.3 and 3.4.4.
the system. Be sure you have programmed the directory code length that you desire as described in
3.4.1. Changing the directory code length after programming the telephone number will erase
all the numbers and directory codes that have been programmed. To program a phone number
that will be referenced to an area code (long distance calls and 10 digit calling), follow the instructions
under 3.4.3 and 3.4.4.
NOTE: If this system is being used in an area that requires 10 digit dialing, proceed to 3.4.3
and 3.4.4 to program the area code and phone number.
and 3.4.4 to program the area code and phone number.
1. Press
* 0 1 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in 3.4.1)
then press * (beep),
3. Enter the seven-digit phone number _ _ _ _ _ _ _ then press * (beep). If the number that
you are entering in this step is less than seven-digits, enter # in the empty spaces. For
example, if the system is connected to a PBX that requires four-digit extension numbers
and you want to enter extension 2217, you would enter this number as 2217#### then
press * (beep).
example, if the system is connected to a PBX that requires four-digit extension numbers
and you want to enter extension 2217, you would enter this number as 2217#### then
press * (beep).
4. Press
0 # TOGETHER to end this programming step (beeeeeep).
NOTE: Only the following Directory Codes may be used: 0, 00, 000, 0000, OR 1, 01, 001, 0001,
OR 2, 02, 002, 0002.
OR 2, 02, 002, 0002.
Page
30
1838-065-L-3-10