BMW 2005 745i Sedan Owner's Manual

Page of 239
 123
Hydroplaning 
When driving on wet or slushy roads, 
reduce road speed. If you do not, a 
wedge of water can form between tires and 
road surface. This phenomenon is referred 
to as hydroplaning, and is characterized by 
a partial or complete loss of contact 
between tires and road surface, ultimately 
undermining your ability to steer and brake 
the vehicle.
<
 
Driving through water 
Only drive through water with a maxi-
mum depth of 1 ft/30 cm, and then 
only at walking speed at the most. Other-
wise, the vehicle's engine, the electrical 
systems and the transmission may be dam-
aged.
<
 
Safe braking 
Your BMW is equipped with ABS as stan-
dard equipment. The best way to brake is 
to apply maximum pressure to the brake 
pedal during emergency: full brake applica-
tion. Since the vehicle maintains steering 
responsiveness, you can nevertheless 
avoid possible obstacles with a minimum 
of steering effort. 
Pulsation at the brake pedal combines with 
sounds from the hydraulic circuits to indi-
cate to the driver that ABS is in its active 
mode. 
Driving in wet conditions 
While driving in wet conditions and in heavy 
rain, it is a good idea to apply light pressure 
to the brake pedal every few miles. Monitor 
traffic conditions to ensure that this maneu-
ver does not endanger other road users. 
The heat generated in this process helps 
dry the pads and rotors to ensure that full 
braking efficiency will then be available 
when you need it. 
Hills 
To prevent overheating and reduced 
efficiency of the brake system, drive 
long or steep downhill gradients in the gear 
in which the least braking is required. 
Otherwise, even light but consistent pedal 
pressure can lead to high temperatures, 
brake wear and possibly even brake fail-
ure.
<
You can further enhance the engine's brak-
ing effect by selecting a lower gear in the 
automatic transmission's manual mode, 
downshifting as far as first gear on 
extremely steep stretches, refer to 
page
. This strategy helps you avoid 
placing excessive loads on the brake sys-
tem. 
Never allow the vehicle to coast with 
the transmission in Neutral – or with 
the engine switched off – as there is no 
engine braking when the transmission is in 
Neutral, and no power-assist for brakes 
and steering when the engine is not run-
ning. 
Never allow floor mats, carpets or any other 
objects to protrude into the area around the 
accelerator and brake pedals and obstruct 
their movement.
<
 
Corrosion on brake rotors
When the vehicle is driven only occasion-
ally, during extended periods when the 
vehicle is not used at all, and in operating 
conditions where brake applications are 
less frequent, there is an increased ten-
dency for corrosion to form on rotors, while 
contaminants accumulate on the brake 
pads. This occurs because the minimal 
pressure which must be exerted by the 
pads during brake applications to clean the 
rotors is not reached. 
Should corrosion form on the brake rotors, 
the brakes will tend to respond with a pul-
sating effect that even extended applica-
tion will fail to cure.
Mobile communications devices in 
vehicle
BMW does not recommend using 
mobile communications devices, e.g. 
portable phones, in the interior of the vehi-
cle without a direct connection to an out-
side antenna. Otherwise the vehicle elec-
tronics and mobile communications device 
can affect each other. In addition, it is not 
Online Edition for Part-No. 01 41 0 159 154 - © 09/04 BMW AG