Behringer Spectrum Enhancer SE200 Leaflet
SPECTRUM ENHANCER SE200
Sound Enhancement Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER SPECTRUM ENHANCER SE200.
This miracle box enhances the sound of almost any instrument by emphasizing the instrument’s
tone spectrum.
1. Controls
(1)
The BALANCE control adjusts the relation between direct and effect signal.
(2)
The SPECTRUM control adjusts the center frequency of the range that will be emphasized
from 500 Hz to 5 kHz.
(3)
The ON/BATT LED illuminates when the effect is activated. It also serves as a battery level indicator.
(4)
Use the footswitch to activate/deactivate the effect.
(5)
Use this 1/4" TS IN connector to plug in the instrument cable.
(6)
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the
9 V battery, press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch
the unit.
◊
The SE200 has no on/off switch. As soon as you insert the plug into the in connector,
the SE200 is on. When not in use, remove the plug from the in connector. This extends
the life of the battery.
The SERIAL NUMBER is located at the underside.
(1)
(6)
(3)
(2)
(5)
(4)