Behringer Rotary Machine RM600 Leaflet

Ultimate Rotary Speaker Modeling Effects Pedal

Thank you for showing your confidence in us by purchasing the BEHRINGER ROTARY MACHINE RM600. 

This ultimate effects pedal delivers the whole history of 3-dimensional rotary speaker effects—at the 

touch of a footswitch. Experience the classic and swirling sounds of famous signature rotary speakers in 

one compact pedal.

(1) 

The FAST control adjusts the rotating 

speed of the drum and the horn 

when FAST is activated via footswitch 

(see (8) ). The range does not overlap 

with the SLOW control.

(2) 

The SLOW control adjusts the rotating 

speed of the drum and the horn when 

SLOW is activated via footswitch 

(see (8)). The range does not overlap 

with the FAST control.

(3) 

The DRIVE control adjusts the amount of 

tube-like overdrive. In minimum position 

the tube stage will be bypassed.

(4) 

The BLEND control adjusts the balance 

between the horn and the drum 

speaker. Turning it to the right will 

boost the volume of the horn and lower 

the volume of the drum.

(5) 

The RAMP switch controls the time it takes to go from fast to slow rotary speed and vice versa. 

You can select between FAST, MED and SLOW ramp time.

(6) 

The MODEL switch selects between 3 famous signature rotary speakers (145, L16 and 122).

(7) 

The two color ON/BATT LED illuminates when active. The modulation is in slow mode when the 

LED lights more red than blue, and it is in fast mode when the LED lights more blue than red. 

The change from blue to red is synchronized with the actual modulation speed.

(8) 

Press the footswitch to activate/deactivate the effect. Hold the pedal depressed for 2 seconds in 

order to switch between fast and slow modulation modes.

(9) 

Use the 1/4" TS IN A and IN B connectors to plug in the instrument cables. For mono use plug 

in IN A only.

(10) 

The two 1/4" TS OUT A and OUT B connectors send the signal to your amp. Use both connectors if you 

want to achieve full stereo rotary effect. For mono use plug in OUT A only.

Use the DC IN connection to plug in a 9 V power supply (not included). 
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery 

(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to 

scratch the unit.

The SERIAL NUMBER is located at the underside.

(1)

(7)

(4)

(6)

(8)

(10)

(9)

(2)

(5)

(3)