Belkin Frozen Dessert Maker belkin bulldog plus- User Manual

 

1.    Turn off your computer. 

2.    Attach the electrical power cable from the computer to the UPS. 

3.    Attach the electrical power cable from the UPS to an AC power outlet. 

4.    Plug the communication cable into the UPS, then plug the other end of 

the cable into the communication port on your computer. 

5.    Start your computer. 

6.    Check the communication type of your UPS. If you select the USB 

option you must have connected the UPS to the computer and install the 
HID driver.   

7.    Place the Bulldog CD in your CD-ROM device and execute the 

setup.exe to run the setup program. 

8.    During the installation, the following dialog gives you 3 options:   

•  Program File: Files contain Bulldog Service, Bulldog Monitor and this 

on-line help.   

•  Audio Files: Some .wav files. These files will be played to notify you 

when power event occurs.   

•  SNMP Files: Bulldog Plus SNMP DLL file. 

9.    After finishing the installation, the setup process will create a Bulldog 

Plus association.   

10.   The Bulldog Plus software is comprised of two modules: 

•  An UPS Monitoring Module (Bulldog Service), which runs in the 

background as a Windows Service and communicates to the UPS.   

•  An User Interface Module (Bulldog Monitor), which enables you to 

control and configure Bulldog Plus through the drop down menus 
and dialog boxes. It also allows you to monitor the UPS through the 
Main Screen.   

Uninstall: To remove Bulldog Plus from your hard disk.   

Help: Bulldog Plus on-line help.   

Bulldog Monitor: User interface, used to monitor and configure your UPS.   

Bulldog Status: Reflect the status of Bulldog Plus service program, the 
service is used to communicate with your UPS. 

Belkin Components 

6