White Rodgers F61-2301 Wallplate for Low Voltage Thermostats Installation Instruction
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI 63123-5398
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI 63123-5398
PART NO. 37-5535A
9524
Printed in U.S.A.
F61-2XXX
Adaptor Plate Assembly
WHITE-RODGERS
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
DESCRIPTION
This adaptor plate assembly is designed for mounting
heating only, cooling only, or heating/cooling thermo-
stats, such as the 1F30, 1F56, etc. This adaptor plate
assembly can be used to mount either horizontal or
heating only, cooling only, or heating/cooling thermo-
stats, such as the 1F30, 1F56, etc. This adaptor plate
assembly can be used to mount either horizontal or
vertical thermostats to the wall or to a junction box. The
wall cover plate covers the junction box, wall damage, or
old thermostat markings. (Note: Some adaptor plate as-
sembly kits may not contain the metal adaptor plate.)
wall cover plate covers the junction box, wall damage, or
old thermostat markings. (Note: Some adaptor plate as-
sembly kits may not contain the metal adaptor plate.)
INSTALLATION INSTRUCTIONS
To prevent electrical shock and/or equip-
ment damage, disconnect electrical power
at main fuse or circuit breaker until installa-
tion is complete.
ment damage, disconnect electrical power
at main fuse or circuit breaker until installa-
tion is complete.
PRECAUTIONS
This instruction sheet is not intended as a wiring guide.
Refer to the thermostat installation instructions to ensure
proper wiring.
Refer to the thermostat installation instructions to ensure
proper wiring.
CAUTION
!
NOTE
INSTALLATION
Do not install the wall mounting plate and subbase at the
same time. The thermostat will not operate properly if
both the wall mounting plate and the subbase are in-
stalled.
same time. The thermostat will not operate properly if
both the wall mounting plate and the subbase are in-
stalled.
For horizontal thermostats, mount as shown in the
following illustrations. For vertical thermostats, ro-
tate all parts 90
following illustrations. For vertical thermostats, ro-
tate all parts 90
°
clockwise.
NOTE
OFF
FAN
AUTO
ON
SYSTEM
COOL
HEAT
Wall Cover Plate
Junction Box
Thermostat
Thermostat
Subbase*
Wall Mounting
Plate*
Figure 1. Mounting thermostat to horizontal junction box
6-32 X
3
⁄
4
” flat-head
machine screws
*Do not use both subbase and wall
mounting plate – see note, above.
6-32 X
3
⁄
4
” flat-head
machine screws