Weider MINI STEPPER WEEMSM1793 Owner's Manual

Page of 4
1. Plug the Reed Switch Wire (8) into the jack on the
back of the Monitor (7). Push the excess Reed
Switch Wire down into the Mounting Cap (17).
Slide the Monitor onto the tab on the Mounting
Cap, being careful to avoid pinching the Reed
Switch Wire.
IMPORTANT: If there is a sheet of
clear plastic on the Monitor, remove it. Make
sure to keep liquids away from the Monitor and
keep the Monitor out of direct sunlight.
INSTALLING BATTERY
The monitor requires one 1.5V “AAA” battery. Slide
the monitor off the mounting tab (see drawing 1 at the
left). Remove the battery cover from the back of the
monitor. Insert the battery into the monitor, with the
negative (–) ends of the battery touching the springs.
Reattach the battery cover. Make sure that the reed
switch wire is plugged into the jack on the back of the
monitor, and carefully slide the monitor back onto the
mounting tab. 
IMPORTANT: Make sure to remove
the battery when storing the stepper.
MONITOR OPERATION
1. To turn on the monitor, press either of the buttons
on the monitor or begin stepping. 
2. To start the monitor, press the ST/STOP button.
The STOP indicator will disappear from the dis-
play. As you step, the monitor will display the total
number of steps you have completed and the
elapsed time. To stop the monitor, press the
ST/STOP button again. The STOP indicator will
reappear.  
3. To reset the monitor, press the RESET button. 
4. To turn off the monitor, simply stop exercising. If
the pedals are not moved and the buttons are not
pressed for a few minutes, the monitor will turn off
to conserve the batteries.
Assembly
Using the Stepper
7
1
8
Tab
17
2. Raise both Pedal Arms (12, 13) to the position
shown. Insert the shaft on the U-bracket (24) into
the round tube on the Base (1). Route the Cable
(22) around the Pulley (23). Push down the Pedal
Arms, making sure that the Cable remains around
the Pulley.
12
13
24
22
2
23
3