Hasselblad 503 Series 10026 User Manual

Camera body 503CW

Reassembly

May 2000

Revision 2

4:2

Fig. 13

Fig. 14

Fig. 15

Fig. 16

Gear alignment

13182

22699

14280

822605

Gear housing

13167

13171

13116

820016

Mount the gear housing (30324) to the mechanism
plate.

On the reverse side of the mechanism plate lubricate
the hub with grease and fit the shutter stop bar (20912)
spring (816802), washer (810404) and clip (817112).
Fig. 13.

Note! The gear housing must be rotated when fitting
the stop bar (20912).

Lubricate the cam of the gear wheel (13182) with
grease and fit to the mechanism plate.

Note! The position of the gear wheel engagement
according to fig.14.

Hold the gear wheels in position and on the reverse side
of the mechanism plate, position washer (810932) and
lubricate the hub with grease. Fit gear wheel (22699)
together with the coil spring. Lubricate the coil spring
with grease.

Assemble the lid (14280) and temporarily secure with
the screw (822605). Fig. 15.
Tension the spring by rotating the gear wheel (22699)
in the direction shown in fig. 14. Test the operation by
pushing the shutter release connecting rod up and down
several times (tension the spring after each operation).
The gear wheels should rotate freely. Fig. 14.

Lubricate with grease and fit the intermediate gear
wheel (13167), bearing bracket (13171), nut (13116)
and two screws (820016).

Position the bearing bracket (13171) and mesh the gear
teeth, secure the two mounting screws (820016).
Fig. 16.

Mounting

position

816802
810404
817112

20912

30324