Well Traveled Living 60354 User Manual
FOR YOUR SAFETY
Service must be performed by a qualified service agency.
Service must be performed by a qualified service agency.
REPLACING THE LIGHT BULBS
This fireplace uses 2 clear 110 Volt, 40 Watt, E-12 socket base light bulbs (small base,
chandelier candle type bulbs). The access plate is located on the back of the unit. For
convenience, if one of the light bulbs burns out, it may be easier to replace both of the
light bulbs at the same time.
This fireplace uses 2 clear 110 Volt, 40 Watt, E-12 socket base light bulbs (small base,
chandelier candle type bulbs). The access plate is located on the back of the unit. For
convenience, if one of the light bulbs burns out, it may be easier to replace both of the
light bulbs at the same time.
WARNING: Do not exceed 40 Watts per bulb. Use of higher rated bulbs may result in a
fire, causing property damage, personal injury or loss of life.
fire, causing property damage, personal injury or loss of life.
Turn off the power to the unit, and unplug it from the electrical outlet.
Let the fireplace cool if it has been operating.
Turn the fireplace so you are facing the back of the fireplace.
Look for the access plate with the gold printing on it.
Remove the 3 screws holding the access plate in position. Once you have removed
the 3 screws, lift the access plate so the 2 positioning tabs come free of their slots.
Once you have removed the access plate you can see and access the two 40 watt
chandelier bulbs.
Remove each light bulb by unscrewing them out of the bases, turning them
counterclockwise. You can use one hand to hold the light socket in place, if required.
Install the new light bulbs by turning each light bulb into the base clockwise. You can
use one hand to hold the light socket in place, if required.
Replace the access plate by inserting the 2 tabs, pushing the plate up against the
fireplace back, and inserting the 3 screws.
Turn the fireplace back so you are facing the front of the fireplace.
Plug the fireplace back into the electrical outlet and turn the power on and enjoy the
flame effect.
Let the fireplace cool if it has been operating.
Turn the fireplace so you are facing the back of the fireplace.
Look for the access plate with the gold printing on it.
Remove the 3 screws holding the access plate in position. Once you have removed
the 3 screws, lift the access plate so the 2 positioning tabs come free of their slots.
Once you have removed the access plate you can see and access the two 40 watt
chandelier bulbs.
Remove each light bulb by unscrewing them out of the bases, turning them
counterclockwise. You can use one hand to hold the light socket in place, if required.
Install the new light bulbs by turning each light bulb into the base clockwise. You can
use one hand to hold the light socket in place, if required.
Replace the access plate by inserting the 2 tabs, pushing the plate up against the
fireplace back, and inserting the 3 screws.
Turn the fireplace back so you are facing the front of the fireplace.
Plug the fireplace back into the electrical outlet and turn the power on and enjoy the
flame effect.
SERVICE INSTRUCTIONS
SERVICE INSTRUCTIONS
1.
2.
3.
4.
5.
2.
3.
4.
5.
6.
7.
8.
9.
10.
10.
On/Off
Power to the unit
Power to the unit
Low heat
700 watts
700 watts
High heat
1350 watts
1350 watts
Your fireplace has the following functions:
Please note: Both the low heat
and the high heat switches must
be in the on position to achieve
high heat.
and the high heat switches must
be in the on position to achieve
high heat.