Heath Zenith SL-9526 User Manual

Page of 16
© 2003 DESA Specialty Products™
598-1147-00
Mode:
On-Time:
Works:
Day
Night
Test
5 Sec
x
x
Auto
1, 5, 10 min.
x
Manual
Until Dawn*
x
OPERATION
* resets to Auto Mode at dawn.
MANUAL MODE
ON-TIME
10 5 1 TEST
10 5 1 TEST
ON-TIME
TEST
... back on.
AUTO
1 Second OFF
then...
Move ON-TIME Switch to
1, 5, or 10 minutes
Mode Switching Summary
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
Requirements
• The Light Control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a
qualified electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
Model SL-9526
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
Motion Sensor Light
Control
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.
Note: When first turned on wait about 1 
1
/
2
 minutes for
the circuitry to calibrate.
Gasket
4 Screws
(2 sizes included)
2 Flood Lamps
2 Wire
Connectors
This package includes:
Light Control
Sensor
Cover
Plate
Lamp Holders
2 Shells
Light Shield
As an ENERGY STAR
®
 Partner, Heath
®
/Ze-
nith has determined that this product meets
the ENERGY STAR
®
  guidelines for energy
efficiency. This product is ENERGY STAR
®
compliant when used with 120 Watt bulbs.
Manual mode only works at night
because daylight returns the sen-
sor to AUTO.
Flip the light switch off for one sec-
ond then back on to toggle between
AUTO and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 10
position.
Put the ON-TIME switch in the 1, 5,
or 10 minute position.
Put the ON-TIME switch on the
bottom of the sensor in the TEST
position.