Heath Zenith SL-9526 User Manual

2

598-1147-00

For easy installation, select an existing light with a wall
switch for replacement.

❒

Twist the junction box wires and fixture wires together
as shown. Secure with wire connectors.

❒

Align the Light Control cover plate and cover plate
gasket. Secure with the screws provided.

❒

Align the three slots in the decorative shell with the
lamp holder pins. Push the shell in and then twist
clockwise to lock. Repeat for other shell.

White to
White

Black to
Black

Gasket

For eave mount only:

❒

Swing the sensor head towards the clamp screw
joint.

If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.

❒

Then rotate the sensor head clockwise 180

°

 so

the controls face down.

Controls

For under eave installation, the sensor head must be
rotated as shown in the next two steps for proper opera-
tion and to avoid the risk of electrical shock. Also for
proper under eave operation,  remove the protective
backing from the Light Shield and stick on as shown below.

Shell Slot

123456789012345678

123456789012345678

123456789012345678

Clamp Screw

Lock Nut

To avoid water damage and
electrical shock, keep lamp
holders 30

°

 below horizontal.

Keep lamps at least
1" (2.5 cm) from the
sensor. Do not allow
the lamps to block
the lens.

Lens

❒

Drill out the holes if
needed to mount the
backplate to the junc-
tion box.

Controls

Controls

Light Shield

Opening

❒

If a wet location junction box was not used, caulk the
wall plate mounting surface with silicone weather
sealant.

❒

Adjust the lamp holders by loosening the lock nuts
but do not rotate the lamp holders more than 180

°

from the factory setting. When screwing in the
floodlamps, do not overtighten.

❒

❒

Remove the existing light fixture.

❒

Route the Light Control’s wires through the large
gasket hole.