Bunn My Cafe AP Owner's Manual
Page 3
CONTENTS
Warranty .............................................................................................................2
Introduction ........................................................................................................3
User Notices .......................................................................................................3
Electrical Requirements ......................................................................................4
Plumbing Requirements .....................................................................................5
Initial Setup .........................................................................................................6
Operation ............................................................................................................7
Cleaning ..............................................................................................................8
Tank Draining ......................................................................................................9
Programming ....................................................................................................10
INTRODUCTION
This equipment is factory set to brew approximately 6-8 ounces of coffee or tea into an awaiting dispenser.
It is only for indoor use on a sturdy counter or shelf. Replace any unreadable or damaged labels.
#00656.0001
#00986.7000
#37881.7002
USER NOTICES
#41177.0001
To reduce the risk of electric shock,
do not remove or open cover.
No user-serviceable parts inside.
Authorized service personnel only.
Disconnect power before servicing.
WARNING
FAILURE TO COMPLY RISKS EQUIPMENT
DAMAGE, FIRE OR SHOCK HAZARD.
READ THE ENTIRE OPERATING MANUAL INCLUDING
THE LIMIT OF WARRANTY AND LIABILITY BEFORE
BUYING OR USING THIS PRODUCT.
00986.7000A 10/07 ©2007 Bunn-O-Matic Corporation
AVERTISSEMENT
• NE PAS SURCHARGER LE CIRCUIT.
• TOUJOURS METTRE LE BOITIER À LA MASSE.
• NE PAS DÉFORMER LA FICHE OU LE CORDON.
• SE CONFORMER AUX CODES NATIONAL OU LOCAL
D'ÉLECTRICITÉ.
• GARDER LES PRODUITS COMBUSTIBLES À DISTANCE.
• TOUJOURS METTRE LE BOITIER À LA MASSE.
• NE PAS DÉFORMER LA FICHE OU LE CORDON.
• SE CONFORMER AUX CODES NATIONAL OU LOCAL
D'ÉLECTRICITÉ.
• GARDER LES PRODUITS COMBUSTIBLES À DISTANCE.
TOUT MANQUEMENT À SE CONFORMER À CES DIRECTIVES PEUT
ENTRAINER DES DOMMAGES À L'ÉQUIPMENT OU PRODUIRE DES
ENTRAINER DES DOMMAGES À L'ÉQUIPMENT OU PRODUIRE DES
DANGERS D'INCENDIE OU D'ÉLECTROCUTION.
VEUILLEZ LIRE LE MANUEL DE FONCTIONEMENT
EN ENTIER, Y COMPRIS LES LIMITES DE GARANTIES ET
RESPONSABILITÉS,AVANT D’ACHETER
OU D'UTILISER LE PRÉSENT PRODUIT.
L' ÉQUIPEMENT EST TOUJOURS SOUS TENSION
LORSQU'IL N'EST PAS DÉBRANCHÉ.
• DO NOT OVERLOAD CIRCUIT.
• ALWAYS ELECTRICALLY GROUND THE CHASSIS.
• DO NOT DEFORM PLUG OR CORD.
• FOLLOW NATIONAL AND LOCAL
ELECTRICAL CODES.
• KEEP COMBUSTIBLES AWAY.
THIS EQUIPMENT IS ENERGIZED AT ALL TIMES UNLESS
ELECTRICALLY DISCONNECTED.
As directed in the International Plumbing Code of the
International Code Council and the Food Code
Manual of the Food and Drug Administration (FDA),
this equipment must be installed with adequate
backflow prevention to comply with federal, state
and local codes. For models installed outside the
U.S.A., you must comply with the applicable Plumb-
ing /Sanitation Code for your area.
Keep hands clear
when closing brew chamber.
Moving parts can pinch.
Keep hands clear
during brew cycle.
HOT liquids can burn.
#00824.0002
41167.2 080811