Graco HUSKY 312877C User Manual
Installation
12
312877C
Fluid Inlet and Outlet Ports
NOTE: Remove and reverse the manifold(s) to
change the orientation of inlet or outlet port(s).
Follow Torque Instructions on page 16.
change the orientation of inlet or outlet port(s).
Follow Torque Instructions on page 16.
Aluminum (
1050A
)
The fluid inlet and outlet manifolds each have
four 1 in. npt(f) or bspt threaded ports (F
four 1 in. npt(f) or bspt threaded ports (F
M, N). Close off the unused ports, using the
supplied plugs.
supplied plugs.
Plastic (
1050P, 1050C
)
The fluid inlet and outlet manifolds each have a
1 in. raised face ANSI/DIN flange (F
1 in. raised face ANSI/DIN flange (F
in either a center or end location. Connect 1 in.
standard flanged plastic pipe to the pump.
See F
standard flanged plastic pipe to the pump.
See F
IG
. 5.
Graco standard pipe flange kits are available in
polypropylene (239005), stainless steel
(239008), and PVDF (239009). These kits
include:
polypropylene (239005), stainless steel
(239008), and PVDF (239009). These kits
include:
•
the pipe flange
•
a PTFE gasket
•
four 1/2 in. bolts, spring lock washers,
flat washers and nuts.
flat washers and nuts.
Be sure to lubricate the threads of the bolts
and torque to 10-15 ft-lb (14-20 N•m). Follow
the bolt tightening sequence and do not
over-torque.
and torque to 10-15 ft-lb (14-20 N•m). Follow
the bolt tightening sequence and do not
over-torque.
Stainless Steel (
1050S
)
The fluid inlet and outlet manifolds each have
one 1 in. npt (f) or bspt threaded port.
one 1 in. npt (f) or bspt threaded port.
F
IG
. 5. Flange connections (plastic pumps only,
1050P
and
1050C
models)
S
T
N
U
W
M
X
U
V
1
2
3
4
Bolt tightening sequence
ti14182a
ti14181a
Key:
M
1 in. fluid inlet flange
N
1 in. fluid outlet flange
S
1 in. standard pipe flange
T
PTFE gasket
U
Flat washer
V
Nut
W
Lock washer
X
Bolt
1
1
Torque to 10-15 ft-lb (14-20 N•m). Do
not over-torque.
not over-torque.