Biostar 915GL-M7 Ultra Owner's Manual
915GL-M7 Ultra
12
CHAPTER 3: HEADERS & JUM PERS SETUP
3.1 H
OW TO
S
ETUP
J
UMPERS
The illustration shows how to set up jumpers. When the jumper cap is
placed on pins, the jumper is “close”, if not, that means the jumper is
“open”.
placed on pins, the jumper is “close”, if not, that means the jumper is
“open”.
Pin
opened
Pin
closed
Pin1-2
closed
3.2 D
ETAIL
S
ETTINGS
JKBV1: Powe r Source Heade r for PS/2 Ke yboard and Mouse
Assignment
Description
1
Pin 1-2 close
+5V
+5V f or PS/2 key board and mouse
1
Pin 2-3 close
+5V Standby
Voltage
PS/2 mouse and keyboard are
powered with +5V standby v oltage.
powered with +5V standby v oltage.
Note:
In order to support this function “Power-on system via keyboard and
mouse”, “JKBV1/JUSBV1/JUSBV3_1” jumper cap should be placed
on Pin 2-3.
In order to support this function “Power-on system via keyboard and
mouse”, “JKBV1/JUSBV1/JUSBV3_1” jumper cap should be placed
on Pin 2-3.
JUSBV1/JUSBV3_1: Powe r Source Heade rs for USB ports
Assignment
Description
1
Pin 1-2 close
+5V
JUSBV1: +5V for USB ports at
JRJ45USB1 & JUSB2.
JUSBV3_1: +5V for JUSB3/JUSB4.
JRJ45USB1 & JUSB2.
JUSBV3_1: +5V for JUSB3/JUSB4.
1
Pin 2-3 close
+5V Standby
Voltage
JUSBV1: USB ports at JRJ45USB1
and JUSB2 are powered by +5V
standby v oltage.
JUSBV3_1: JUSB3/4 are powered by
+5V standby voltage.
and JUSB2 are powered by +5V
standby v oltage.
JUSBV3_1: JUSB3/4 are powered by
+5V standby voltage.
Note:
In order to support this function “Power-on system via keyboard and
mouse”, “JKBV1” jumper cap should be placed on Pin 2-3.
In order to support this function “Power-on system via keyboard and
mouse”, “JKBV1” jumper cap should be placed on Pin 2-3.