Brother MFC-J4710DW Quick Setup Guide
6
c
Remove the orange protective part a.
d
Unpack the ink cartridge.
Turn the green release lever on the orange
protective packing a counterclockwise until it
clicks to release the vacuum seal. Then
remove the orange protective packing a as
shown.
Turn the green release lever on the orange
protective packing a counterclockwise until it
clicks to release the vacuum seal. Then
remove the orange protective packing a as
shown.
e
Take care to match the sticker color a with the
cartridge color b as shown in the diagram
below.
Install each ink cartridge in the direction of the
arrow on the label.
cartridge color b as shown in the diagram
below.
Install each ink cartridge in the direction of the
arrow on the label.
f
Gently push the back of the ink cartridge
marked “PUSH” until it latches. After all the ink
cartridges are installed close the ink cartridge
cover.
marked “PUSH” until it latches. After all the ink
cartridges are installed close the ink cartridge
cover.
NOTE
Do not throw away the orange protective part.
You will need it if you transport the machine.
You will need it if you transport the machine.
IMPORTANT
• DO NOT shake the ink cartridges. If ink stains
your skin or clothing, wash with soap or
detergent at once.
detergent at once.
• DO NOT touch the cartridge in the area
indicated b, as this can cause the machine not
to function with the cartridge.
to function with the cartridge.
1
1
2
1
2
NOTE
The machine will prepare the ink tube system for
printing. This process will take approximately four
minutes. Do not turn off the machine.
printing. This process will take approximately four
minutes. Do not turn off the machine.
1
2