Behringer V-TONE GMX110 User Manual

V-TONE GMX110/GMX210/GMX212/GMX1200H

4. EFFECTS PROCESSOR

Once you activate MIDI, FX tracking is no longer active,

i.e. there is no assignment between an effect number

and a channel. This means that when you switch a

channel, the previously set effect is not automatically

loaded up. As this assignment feature would probably

cause confusion when controlling the V-TONE via a

MIDI foot controller, it makes sense only when it is

controlled from the enclosed footswitch or directly

from the V-TONE. To operate your V-TONE without

MIDI remote control, please disable the MIDI function

(display reads OF).

You can control different functions of your V-TONE using

MIDI. To this end, the V-TONE receives MIDI instructions (so-

called messages). The messages that need to be sent to your

V-TONE have to be created either on a MIDI foot controller or on

a MIDI sequencer. Basically, these are Program Change

Messages and Controller Messages:

Pro gram Changes: You can dial up presets using MIDI

program changes. Since program changes start at 0 and go up

to 127, program change 0 corresponds to preset 1, program

change 1 to preset 2, and so on (compare table 7.1 in the

appendix). After the switch is done, the preset is directly active,

i.e. independent from a possibly set bypass.

Effect parameters: Three parameters of the effects

processor can be adjusted in real time. This way, you can create

your own effects, modify existing effects to your specific needs

(e.g. adapt the delay time to the tact of your song) or remotely

control using a MIDI foot controller.

Select a controller number for the footswitch on your MIDI foot

controller. Use control numbers 12, 13 or 14. Using the footswitch

on your MIDI foot controller, you can now modify the values of

the three adjustable parameters in real time or directly enter their

values. Which three parameters for the respective effect can be

edited is shown in the following table: