Black Widow Security BW-1500 Leaflet

Page of 2
VEHICLE SECURITY SYSTEM
BW-1500
CHALLENGER
PLUS
USER INSTRUCTIONS
CONGRATULATIONS on your purchase of the CHAL-
LENGER PLUS remote vehicle alarm. You now own the most
reliable security system available today, utilizing the latest state
of the art technology. It is American made, designed and engi-
neered by leading experts in the security industry.
The CHALLENGER PLUS comes with two 2-button code
learning remote transmitters, flashing L.E.D., electronic sensor,
and many additional features. It can be programmed as a manual
or passive system. A number of these safety and convenience
features can be programmed into your system either by the
installing dealer, or in some cases yourself (explained below).
With minimum care and upkeep, this alarm will give you many
years of service and protection. Read the following information
carefully
. It will help you get the best from your system.
A) MANUAL OPERATION
1) TO ARM – Press the left button.You will hear 1 chirp,
parking lights will flash 1 time, and the L.E.D. will flash slow
ly after button is pressed.This indicates your system is 
armed.
2) TO DISARM – Press the left button.You will hear 2 
chirps, parking lights will flash 2 times and the L.E.D. will no 
longer flash indicating the system is disarmed. If doors are 
not open before 30 seconds, alarm will re-arm itself.
B) PASSIVE OPERATION
1) TO ARM – If your installing dealer has installed the 
CHALLENGER PLUS as a passive system, the alarm will 
arm automatically approximately 30 seconds after the last 
door is closed. (Note: you can also arm immediately by 
pressing the left button as in #1 above).
2) TO DISARM – Disarm system same as in #2 above.
3) VALET – Your dealer installed a valet (push button) 
switch in a convenient location in the dashboard area.To 
activate the valet, push for 5 seconds prior to turning off 
the engine.The L.E.D. will stay on (non-flashing) while the 
vehicle is in Valet.You can now leave the vehicle without 
arming the system.While in valet, with the alarm inactive,
you can still lock/unlock your doors with the remote trans-
mitters. See section C.To deactivate from the valet mode,
turn on  the ignition and press the valet switch for 5 seconds.
C) DOOR LOCK AND UNLOCK
1)  If your vehicle has electronic (automatic) door locks,
and your dealer connected them to the alarm, the 
CHALLENGER PLUS will also lock when arming and unlock 
when the system is disarmed in either manual or passive 
operation.
2) Your system can be programmed by the dealer not to 
lock 
in the passive mode. In this case your system will arm 
passively, but you must press the left button to lock the 
vehicle.
3) Your door locks can also be programmed by your deal-
er to lock when the ignition is turned on and to unlock 
when the ignition is turned off.
If you have questions, ask your dealer to explain these very conve-
nient features to you.
D) AUDIO-VISUAL WARNING INDICATORS – 
When disarming, if you hear 3 chirps (instead of the normal 
2) and the L.E.D. is flashing rapidly, it means either an entry 
violation was attempted or your vehicle was bumped hard 
enough to cause the alarm to trigger (check your vehicle to 
make sure everything is working and there is no damage).
E) REMOTE PANIC – An important safety feature on your 
CHALLENGER PLUS system is a remote panic which will trig-
ger your alarm a substantial distance away. Press left button 
for 3 seconds until siren sounds.To stop the siren, press the 
left button.
F) STARTER INTERRUPT – As added protection, the 
CHALLENGER PLUS has a built-in starter interrupt.When the 
system is armed, the vehicle cannot be jump started, hot 
wired, or started with a key.This makes it extremely tough 
on any theft attempt.When you use your transmitter to 
disarm the system, the vehicle can then be started normally.
(Continued on Reverse Side)
Please Keep For Future Reference
TO USE THE CODE LEARNING
SEQUENCE FOLLOW THIS PROCEDURE:
1. Turn the ignition switch ON/OFF 3 times, leave 
ignition ON the 3rd time.The SIREN will chirp 
once and the Door Locks (if connected) will 
LOCK.
2. Within 5 SECONDS, press and HOLD the Valet 
Switch for 5 seconds, the SIREN will Chirp 3 
Times and the L.E.D. will turn SOLID.The System 
is now in Code Learning Mode.
(Continued on Reverse Side)