Bay Technical Associates BayStack Fiber Media Adapter User Manual
893-863-A
5
Redundant Enable Jumper
Jumper JP1 is used to set the port to operate in the redundant port
mode. The 10BASE-FL RDN Media Adapter is shipped with the
redundant port mode set to off.
mode. The 10BASE-FL RDN Media Adapter is shipped with the
redundant port mode set to off.
To set the port to operate in the redundant port mode, perform the
following steps:
following steps:
•
Locate the shunt covering the JP1 jumper pins on the media
adapter board.
adapter board.
•
Gently remove the shunt from the two far left pins.
•
Replace the shunt over the two far right pins.
NOTE:
Jumpers JP2, JP3, and JP4 are not
user-configurable.
Jumper 1
RDN EN
JP1
JP1
RDN EN
Default
mode
Redundant
mode
6771